Wireless

Dear, i have 12 caps(3602) and one 5508 controller, i have configure all the things, but when i have enable the hight-thoughput (n mode), then no win7 laptops are connecting, but when i will disable it then it is connected with 54 mbps, so what will ...

Hi,Can a Cisco Autonomous Bridge connect to an LWAPP AP and re-broadcast the SSID's? As in acting like a wireless repeater?Thanks

Hi All,We have an existing 4400 controller with MAC filtering for clients configured. Right Now, we are migrating to 5500 WLC and ISE setup.We want to use MAC filtering due to company policies on the new Controller as well as ISE. Is there a way (fro...

Hi FolksI saw the below in wlc controller ,what this mean,how to fix this issue if anyMost Recent Traps SNMP Authentication Failure: IP Address: 192.168.10.2

We are running 7.6 on our 5508-WLC.  We have a number of issues w/ 'i-clients' when they go asleep.  From what I can tell, I need to enable the 'sleeping clients' feature (not just the session and idle timeouts). On our WLANs we use Layer-2 (WPA+WPA2...

I have a WLC 5760 and i did below configuration for WLAN:wlan 3 85 GUESTS client vlan 85 no security wpa no security wpa akm dot1x no security wpa wpa2 no security wpa wpa2 ciphers aes session-timeout 1800 no shutdownthe ap is joined with WLC:EFFAT-W...

I have started to look into configuring our 3850 as a WLC I enabled the command wireless mobility controller Then I tried to connect to <switch ip>/wireless I just get a dead page. I configured the wireless management vlan but still no joyWhat basic ...

Hi,Im currently migrating 2,400 APs to change controller addressing.Id like to know is their a report on NCS i can run that will show me the AP config for Pri/Sec/Ter controller configWe are running  1.3 (1.3.0.20)Ive had a look around but not found ...

Hi everybody!I'm having a headache with a problem, i hope you can help me guys.We have a WLC 5508. This WLC has a guest network, which SSID was hidden. Now that i want to use, i enable the SSID broadcastand try to connect to it.With my laptop, or any...

Hi.I have a WLC 5508 connecting directly to a distribution switch (3850) via a layer 2 etherchannel trunk fibre link with LAG enabled on the WLC.Whenever there is a loss of power to the server room where both devices are hosted & power later gets res...

I have a WLC 2504 & tried installing a permanent license onto it via tftp but kept getting the error message below:"% Error: License file transfer failed - Error from server: Bailing out to bad characters in filename"Tried using tftpd64 & also solarw...

Hi,Some of our AP's oper status are getting down. Their admin status are enabled but why they are getting down? Even I reboot the AP they are still down.Our software version is : 7.5.102.0Controller 5508Thanks.