Wireless

Folks,          I am trying to do Leap and Eap-TLS together. How can I write a policy in ACS that would check for identity before choosing the right profile for the request. ACS 5.2 does not support Native eap-tls. I am assuming I will be using Ideni...

Hey guys,I have been searching but couldn't find the topic. I am aware of an app that works like the Cisco Network Assistant on the ipad, but for the life of me I can not find it.Are there even such an app I can use on my vast network using my iPad.W...

Hi,I  'm trying to upgrade WLC 4402 up from 5.1.151. After upgrade to 5.2 or higher https  interface is inaccessible. If I use any other previous version, all is  OK. Somewhere I found  recomendation to open http before upgrade and use it at first. I...

Hi,I want to connect a VDSL Modem with the WAN Outside Interface Fa0/0 of my ASA5510.The ISP use for VDSL a Vlan 7 tagged.What is neccessary to configure in the ASA to establish a Internet Connection over VDSL?ThanksSent from Cisco Technical Support ...

Hello, I need to reactivate my DHCP Proxy but I cant.I'v get this message : Failed to update dhcp proxy.In Cli mod : Message Log Severity Level ...................... ERRORcan you help ?

Hello EveyoneI have write one external web page but i dont know why not auth pass?my web page can pass or fail to auth my radius and display to screenbutcontroller how know client use auth is pass or fail ??ths!

Hello,Presently I managed some AP1242AG in ofiice areaI need implement WPA and MAC filtering.I found what :In IOS 12.2(13)JA branch IOS and before, MAC authentication was supportedin conjunction with WPA.In 12.2(15)JA and above, configuring MAC authe...

Hi Expertsany AS Image on CCO for the Cisco AP 1260,if so how to download it to the flash of the ap then boot properly the new code for standalone? thing is that have one with lwap enable so that i cant do any thing ,upon booting it looks for control...

Is there a command that when entered into a Dell switch which will list all MAC's and corresponding ports which they are plugged into? I only know of typing 'show bridge address-table ethernet e*.' which requires you to go to every port in the switch...

HiI have 5508 WLC (Running 7.2) in seperate buildings. I have created ACL's on both Controllers and the only thing that is failing is the Mobility Control Function. The ACL on WLC B is the Exactly the same except with some IP's being reversed. I have...

I have a ISR 2811 with NME-AIR-WLC6-K9 WLAN controller. I have problem booting the WLAN controller.  When I try to have an access to the module (service-module Integrated-service-engine 1/0 session), it keep rebooting with the message : Booting from ...

Could someone recommend a good book for deploying WLCs?

HiIf I'm reading correctly Load Balancing is not advisable if using voice of wifi.On a conroler with 70.220 - Wireless - Advanced - Load balancing          Load balancing - client windows is default 5, max denial 3But on the wlan, the load balancing ...