Wireless

I've rebooted my ASA5540 and the message appeared only "booting system, please wait..." nothing else happened. Can anyone give any suggestion?---Posted by WebUser Wanphen Jenveshprasert

Hello,I try to configure an Aironet 1142 but I have some problems.The AP gets an IP address from dhcp, but then can not connect to HTTP. The hyperterminal connection is functional, I enter EXEC mode but the CONFIGURE command does not exist.I tried to...

Hey guys,We have some remote H-READ APs at a branch office and a 7921 phone which drops calls/loses audio when roaming between APs.We are just using WPA2 without any 802.1x or CCKM/PKC.Do we absolutely have to set up a radius server/8021.x/EAP to ena...

Is there currently any supporting softwares, open betas, or planned product support for the windows phone 7.5 platform?If so, where is this software.Thanks,Dan Regalia

Hi, I seem to be having an issue with some remote APs booting into local mode. They tend to get stuck in a boot loop or become unavailable. I have worked with TAC but no real solution has been found.My question here...Is there a way to make the WLC a...

Dear,I am trying to associate a 1120 and 1231G AP's to cisco WiSM 1 ios version 5.i have started with converting the AP's to lightweight image using TFTP. and then connecting them directly to the cire switch and configure the port as follows:interfac...

Hello, I have problem in this wirelles router. How to enable web interface via the console? (Port COM1) Command Ip http server is bad.System say unknown command,Why? This device is new.Start device: I hold mode button and switch on power supply.LED i...

Hello,I am using a spa508g with 7.4.9c. I think I have found a bug.I use TCP for signaling.I receive a call,I send a REFER using blind transfer. The phone first send a invite to put the call in hold (as soon you hit bfer), then the refer. If I then t...

Hi,I am looking for an access-point or a router that has DHCP-client enabled on its Wireless side. Imagine all computers/devices are wired and don't support wireless. Here is a diagram:Service Provider----))))))))  Wi-Fi/802.11a/b/g/n (((((((((((((--...

Having an issue with connecting the WLC to an HPVlan 1 dataVlan 2 voiceVlan 10 WLCWhat are the settings on the HP to connect to the WLC?

Does anyone have any info on a WLCM 2 Controller Card?

Hi, i started getting this weird error message yesterday in WCS.http://dl.dropbox.com/u/10913656/xda/Clipboard02.jpgI have some generic and some per location templates.Admin status on/off, hreap enable are generic.Then i have templates for every loca...

I am trying to assign a static ip and default gateway to my LAP through the CLI, but after I reboot it, I lose the config and it reverts back to dhcp.Is there any command to save the config to the AP through the CLI?  I've tried all I can think of (i...