What automation platform do you use on 5520 and 9800 WLCs? We have a mixed environment. We are also beginning our journey to convert a lot of manual tasks into code. So far we have looked at and worked with CatCenter (DNAC), Python, NETCONF/YANG and ...
Forum Posts
Hi,For Meraki local authentication with an LDAP server what are the Pre-requisites ? and is certificate must or is it optional if i am going with only LDAP & not LDAPs ?
I have a AIR-CT2504-K9 controllert (version 8.5.182.0) with 20 APs. All of them except 2 are power up with PoE. The two that are not working with PoE connect to the WLC with the Fallback Ipv4 Address, and not with the static IP address configured. I ...
Any guidelines on resolving the high latency observed here -
Resolved! License Question
Hi All.I'm new here. I have a question regarding licenses per device. When a device (AP) is not online does it consume a license?AP's that are attached to a site and offline (Basically they are spares)Do they use a license or only when they are onlin...
Been working more and more with the 9800 WLC's recently and starting to get more comfortable with them... Does anyone know what the equivalent CLI command is in the 9800 WLC for "config ap primary-base WLC03 Cisco_AP_1 192.168.142.12" That was used ...
Hi Meraki Community,I just want to ask about EAP timer settings and the best and most recommended Practice. Currently, we have below settings and Users are experiencing wireless issues as these timers are crossing values. Please suggest.
Resolved! Meraki PCI Scan for bulk networks
Hi, I am attempting to use the PCI Scan tool under Wireless->PCI report in Meraki. The scan can be done on a per network basis. Does anyone know how to run a PCI scan for all networks inside an organization without having to manually go to each netwo...
What LAN controller series support? I bought AIR-AP3802E-C-K9 6 units I'm using the current WLC 5508 Software Version :8.0.133.0 to manage won't working please advice
Hey guys, I have this AP and I can't login on it after performing a full factory reset. I'm not able to write anything when it finishes the boot and I receive the "user access verification" message. After that these messages start in loop (wired0 ema...
Hi All,I have a single Meraki AP plugged into a 3rd party router in bridge mode which since migrating the wireless over chromecast to google play and printing has stopped working.I suspect this is due to how the Meraki device is handling bonjour pack...
Hello,we have a problem within our infrastructure.All access points are offline and unreachable from the Meraki dashboard.I have already rebooted switch and mx but with no results.We have manually reset from the 1 access point key, to no avail.Remove...
Resolved! WLC 9800-80 HA backup/restore
Hello,I currently have two WLC 9800-80's running 17.3.6 setup in HA. If I need to restore a config do I need to first unpair the WLC's from HA before I restore the config?Secondly, I'm standing up a pair of WLC 9800-L's that are also going to run 17...
Hi, I m really struggling to get 9164 access points to join a 9800 controller. I get this error on the console of the Access point dtls_log_replay: dtls_log_replay: DTLS Replay Attack detected for Source. I don't know if this is the reason for the AP...
I heard that the client disconnects every certain time, so I checked on pi 5min 1sec10min 2sec15min 3sec... It was confirmed that it was randomly cut off every 5 minutes like thisI think it can be said that there is no enable timeout or idle timeout ...
