Wireless

Hi everyone,We are adding two bridges for a point to point link connecting two buildings. Currently, we have a wireless controller running 4.2.207.0 at the site with several AP's connected and room to spare for the bridges. Should I convert my two 13...

I have 1242 Access Points that I updated to C1240-k9w7-tar 124-25d-JA tar last week.  Also updated WET200 to WET200-FW-2.0.4.0-k9.img (December 2010 version).  Suddenly the bridges don't seem to stay up/communicate with the AP -- Any Ideas -- can I r...

Hello,I need to upgrade two WISM to 7.0.116.0 to be able to support 3500 series APs.Each controller in the WiSM has about 75 APs, these are mixture of 1232 and 1142 access points. I also have 4402 working as an anchor controller.Anyone knows of any i...

Hello,I would like to know if this traffic is correct... (wan link - remote APs)minute:15 minutes:I think that something is wrong... there is a high bandwidth utilization.All APs are configured with h-reap and local switching.All traffic wan link - 1...

Hello i have an Cisco ap and i can not activate channel bonding on 5Ghz InterfaceI set the channel 116 in 5Ghz at 40Mhz but i says the active channel is 116 at 20Mhz (DFS enabled but)i atached to this thread the print screensHow can i setup the chann...

Hell, my problem is configure multiple workgroup brige (ap  WGB) with the same ap air-lap (a lightweight access point), I find written documentation on the WGB establishes a single connection to the lightweight access point

Dear alli hope your doing well,i have a university project for unified wireless network deploymentthere i have two 6500 series two core switchesi have four wism card to install in that chassies and have 800 ap of 1242 seriesactually i did wlan setup ...

I have a question I have 3 wireless SSID and 3 with 3 vlan's now my question I would like 2 more but that does not work how can you solve that

I have a question, it is possible to wireless mac address authentication and then asks him a password ?

dear alli have wcs spftware installed on windows server 2003 now i want to take its backup on my laptop to install it on another server, i already found books to do that from cisco's site but really i could not do that,please share with me how i can ...

Hello guys, I need some bailout here. I have a WLC 5508 which i have configured for AP's but i would like to use the windows server 2008 as the radius server to authenticate the Active directory users.Can i use a separate windows server 2008 as the r...

Buenas tardes quisiera saber si alguien me podria ayudar con un problema. Tengo una central UC-540 y quiero configurar dos SSID una para datos y otra para voz, cuando creo la red inalambrica para datos no me da problema, el problema es cuando quiero ...