Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Is there a third party omni antenna that is more powerful then the cisco 9bi antenna (AIR-ANT58G9VOA-N ) that I can purchase?ThanksJustin
I have Cisco AIR-LAP1131G-E-K9 but now I want to convert it to Autonomous. I am trying the method of IOS upgradation the way mention on the forum and cisco site but I am not able to do that.process_config_recovery: set IP address and config to defaul...
I am trying to manage a Cisco 4402 using non-default snmp communities from Cisco Works RME 4.0. RME Credential Verification fails with “Device Not Supported” recorded against selected option; however, the controller does respond to snmp queries. Th...
Hi. I have a WLC controller with webauth athentication using an external RADIUS for authentication and accounting. Everything is working fine, except that the accounting updates only happen at session start or stop, and sometimes (!?) there are int...
The 1131 Access point in IOS mode had an option to turn off the BLUE LED circle on the access point. The access point has been converted to LWAP and connected to controller and now the BLUE LED circle is back.... is there any way to turn it off ??Can...
Which Cisco Works is compatible with Wireless LAN Controller, for example 4400 series?
Hello,I purchased the following devices as part of the Cisco Mobility Express Solution:2 x Cisco 520 Series Wireless LAN Controller2 x Cisco Catalyst Express 520 Series Switch8 x Cisco 521 Series Access Point ( AIR-LAP521G-E-K9).1 x Cisco RV042 Route...
Hi, Having successfully connected the handset to our system. We came in this morning to play a play a little more. The trouble is the phone will not connect to any network. It just sits there saying "Acquiring Network". I have checked the usual stuff...
Hi,Can someone help me for configuring N-Series band on Cisco 1252 Access Point in IOS Mode.ThanksTabrez
I bought a group of 10 Aironet 1232AGs, and after I enter enable mode cannot enter configuration mode using config t. I think the reason why was because they may have previously been controlled by a WLC. Is there anyway to sort of "reset" them so tha...
why do we need radio interfaces in AP. what is the purpose of creating sub interfaces.
Version 5 software all works OKUpgrade to 6.0.1285Gig radios all disabled with errorAP on the 802.11a radio with Base Radio MAC xx:xx:xx:xx:xx:xx (APxxx.xxxx.xxxx) is unable to associate. The regulatory domain configured on it '-A' does not match the...
I had a strange happening just recently and I can not explain what happened. I was hoping that someone may beable to shead some light on what may have been happening. I was running a WLC 2125 with 24 AP's (6 1252's and 18 1142's) The location was w...
I want to develop a telework solution in my company using the function H-REAP of the centralized system.My intention is to develop it with "zero configuration" in the employee's home and may serve any access for any service provider.What configuratio...
Hello, I am in the middle of implementing a Singlewire PushToTalk system in a wireless network with Cisco 5508 WLCs and Cisco 7925 phones. I managed to configure everything and PTT works with the exception that from time to time there is a i...
