Wireless

I need some help in determining if we are experiencing a bug or a configuration issue. Let me start by giving you details of how we are set up.We have a WLC 4404 running 5.2.178.0 at our corporate office. Our remote offices are running a 1242 AP in l...

From memory, the latest WLC software (and possibly older versions) allow channel 165 to be disabled. I can not find this functionality on the 1250 or 1140 (autonomous). That is, I want to exclude DFS from picking ch 165, obviously because I would lik...

Hi,Does it have any disadvantage to enable both interfaces at the same time?regards,

Folks, Is it possible for the SSC client to connect to two networks at the same time? it seems it does have an option for connect and connect exclusively, I am not sure what the difference is.

Hi everyone.I'm running WCS 6.0.132 with WLC 6.0.182 and I'm trying to build a Lightweight AP template to assign NAME-VLAN mapping on different AP running H-REAP.When I create the new template I setup AP in H-REAP mode and then enable H-REAP/REAP con...

Hi,attached is the output of "show country supported tx-power" command in WLC6.0.From there you can see the max tx-power for each country. From the output, u can see that most of the tx power is 20dBm for b/g. However, in the CCO doc "channels and ma...

GentsI configured an autonomous access point as being a repeater to a root one. I ping the root from the repeater and it is showing as connect. however,the wireless coverage has not been extended?what is the problem?

I downloaded the USB-Install-7921-7925.1-0-2a.exe from CCO. I tried to install it but I am getting a Microsoft Logo failure message. The instructions said I would see that. Per the instructions, you can say Continue Anyway. When I get my error I don'...

Hi,Can anyone tell the detail proceture/doc to remove software version 6 from a WLC 4400 and install a lower version of 5.1?Thank you!

Hello All, I am putting a document together and need some "live hanging" 1142 and 1250 LAP access points. I have searched the internet to no avail. I want to display office ceiling, wall mounted and drop down from ceiling 1252 APs. Any ideas where I ...

I am looking into configuring an 881W to leverage WLC devices on our network. They follow the same paradigm as the LWAP's so I understand the DHCP option 43 and all of the tunneling and discovery process. However, I have a question about how the embe...

My customer is running a 2700 appliance that has received little attention for about 2 years. I'd like to wipe it out and start over and I'm looking for a rescue image/ISO.I can't find one. Nearly every other Ciscoo appliance has one of these. Does a...

Hello,I have a wlan that uses both the 5ghz an 2.4ghz radios in our 1131ag's. I'm having some issues configuring the 5ghz radio so it is someone useful.These ap's were installed after a survey using the 2.4ghz radio of an 1131, so the building was su...

Hi,I have two 1310G bridges, one configured as a Root the other as Non Root. The root is attached to a 3560 switch. I have configured VLAN 15 (Management) and VLAN 573 (Client) on the 3560. The Root and Non Root bridges have the same VLANS, and VLAN ...

Is it possible to set up a management SSID and having specific WAP's only offer up this SSID. I need to make sure the wireless is going to work for our executive manager no matter where our manager is in the building.