Wireless

Dear all I knew that 7920 is not supported by cisco to work with 1252 AP. (7920 can't authenticate with the access point although that 7921 is working fine)I red in other conversations that the problem in TKIP encryption , but it doesn't work with WE...

We have an autonomous wireless network that is using WPA/TKIP, and authenticating back to a Windows 2003 IAS Server. We are going to be adding wireless to other offices, and are looking at implementing WDS. I have found documenation on Cisco's site r...

Good morning!Just have a general question, is there a command on a Cisco 1231 AP to display a list of adjacent APs and their SSIDs? Thanks!Difan

Hi,I'm looking at installing a new 802.11g based wifi network. However in the same facility there's a very old (from 1999) 802.11? network running. Don't know much about this old wifi network, but any idea's on whether this old network would cause an...

I have cisco 881G router with (C880DATA-UNIVERSALK9-M), Version 12.4(22)YB2. It has one 3G card (PCEX-3G-HSPA) with Modem Firmware Version = F1_2_3_15AP C:/WS/F.I have configure the 3G card but I am not able to get the IP address from the Service Pro...

Has anyone got an idea on when a 6.x Assurewave version will be available?

HelloI have a problem with an AP which is not joinig the wism. The log at the wism tells me:*Oct 12 14:07:08.866: %LWAPP-3-RADIUS_ERR: spam_radius.c:138 Could not send join reply, AP authorization failed; AP:*Oct 12 14:07:08.856: %LWAPP-3-PAYLOAD_MIS...

Hi,I want to integrate WLC with windows 2008 server. If anybody done this integration i would like to know what are the step i need to do in the Microsoft Side, If you have any document related to MS 2008 integration pls share the information with me...

Hi,I am using autonomous Cisco 1242 AP's with Teklogix terminals running Windows CE.The Teklogix consultant wants us to enable CCX support on our AP's so that the terminals stay connected to the network when they are in power-save mode.Can someone pl...

Hi,Picked up a few 7920's second hand (yes, there old, but they are for my lab) - needless to say, the last person to have them locked them down pretty tight. It seems they are set to "Disabled" (as in, past restricted) - basically I can not change a...

I guess this is a feature request:We are building a client portal where the client can check their bandwidth, ports, etc, get info and so on. I would like to be able to embed the client count, radio count, etc from WCS.I am able to pull similar info ...

Hi all, Do you recommend 5500 series controller for 1140 or 4400 series, as 4400 series is cheaper.and i guess for normal wireless functionality, and in future WCS integration 4400 series does the job. any advice? - SID