Wireless

All,The design guide specifies the following limitation: "As designed, 4400 series controllers do not forward IP subnet broadcasts from the wired network to wireless clients across the EoIP guest tunnel."Does this mean that i cannot initiate a connec...

We currently have a point to point bridge set up between 2 of our buildings. We would like to set up a second bridge between the buildings and etherchannel them together. The problem is that we have a small line of sight and will need to mount the se...

I have a need to deploy wireless in the auditorium to support up to 100+ users.I understand that Cisco doesn't recommend more than 25 clients per AP but how can I control the spread of how clients associate with the AP?Also, so does this mean I shoul...

Hi All, does anyone have experiences with measuring of Power density S with the Cisco Spectrum Expert? I know that there is no direct way to do so, but is there a Formula or Algorithm to convert dBm in mW/squaremeter? I know that some of the Guys who...

I have an AP that keeps disappearing and reports "Warning: AP with Base Radio MAC has found its IP Address being used by a machine with MAC Address"What can I do to stop this?

Hi All: My WLC already firmware already update to latest version 6.0 and the management ip and ap manager ip in the same subnet, DNS record already have the CISCO-LWAPP-CONTROLLER and CISCO-CAPWAP-CONTROLLER A record.But Some lightweight AP cannot jo...

I have two 1231 autonomous access points operating in workgroup bridge mode. How far can I take them in an LWAPP conversion and still operate in workgroup bridge mode?

4404-100Q1. What are the commands to backup the configuration for a 4404 WLC.Q2. What are the commands to restore the backup configuration file for a 4404 WLC.Thanks

Anybody have any idea what causes 802.11A radio stuck in Interface Reset, Line Protocol Down

I managed to discover all my AP, but most of the AP are in "yellow" instead of "green". When I click on the "RM Verify Capability", it failed on the "WLSE-WDS Authentication Test Failed".May I know what will cause this??

WLAN Controller 4402, software version 5.1.151.0; 1131AG APsA problem started several weeks ago after the WLAN Controller was powered down/up in order to move power cords. Now, we are experiencing a problem with the 1131AG APs associating with the WL...

Hello All,I recently purchased 6 1142 AP's and added them to my controller, well since these are not LWAP but instead CAPWAP AP's they were not supported by my WLC with code version 4.2 (not the end of the world) so I upgraded the WLC to code 6.0.182...