Wireless

I have got 2 Aironet 1000 series running (with 2000 series LAN controller). I use to have a constant speed of 54Mbps with excellent signal until a week ago. Now the speed is always fluctuating, once i/anyone gets connected is starts falling until it ...

HI All,does any one has configured WiSM with multiple VRF on 6500. I have 2 6500 with 3 VRFs & one WiSM in each core. there is no communication between VRFs & my wireless users are spread in each VRF, now I want to configure these WiSM in such a way ...

hi, i'm not capable to configure an Email Notification on the WCS.Location->Notifications->settingsi create a new Event->new Event Nameuntil here there are no problems, but now i would like to add a "destination and transport".if i fill in all fie...

Hi,What is the maximum height at which a light weight integrated antenna AP can be placed?Regards

Running WCS 4.1.83.0 with WiSM controllers 4.0.217.0.I have renamed and replaced several AP 1240's and I am still seeing the old AP names and duplicated to the New AP names in the WCS(Old names corresponding to the newly named AP macs). I can only se...

Device: 350 Series PCMCIA.Can run Aironet Client Utility and get Firmware version from Status page. Need to be able to do this remotely on many clients. Help greatly appreciated.

Heres my problem, remote site standalone AP, users failing authentication. Radius key is configured correctly. Radius server log shows the EAP information blank for the authentication requests.The AP configuration has been checked and double checked....

All,What's everyone's take on the relative RF performance value of wall vs. ceiling mounted APs? Assume standard attached dipole antennas and a standard ceiling height of 10 feet.Thanks all,--Bruce Johnson

Hi,I am trying to install Cisco wireless IP Phone 7920 with Unified Call Manager Express Wireless AP 1241 configured with PEAP and WPA Does the 7920 phones support PEAP ?RegardsMohamed

Hi, While using the 7920 over the wireless network, what are the reasons for which a call can be dropped? There is a ring going, but when the call is picked the call gets dropped.Regards

Greeting,I want to enable IDS feature in WLC to forward the Data to IDS,,,Should IDS be from CISCO or it could works with any vendor?

i have two vlan on 1200 ap. one vlan is for wifi user and the other mgmt vlan is just for mgmt. of ap from rest of the network. i don't want to associate this with a ssid. i don't want the wireless users to be able to get on using this ssid at all. a...

Hi,is it possible to have PEAP-MSCHAPv2 authentication and MAC Authentication against Central Cisco ACS, on the same Access Point on different SSID's without conflicting with each other?ThanksJorge

Dear AllHow do I connect one Aironet 1300 Series Wireless bridge to Wireless Lan controller 2006?I tried to do the following, but it didn't work!lwapp ap ip address 10.10.10.2 255.255.255.248 (it doesn't accept this commands!!!)lwapp ip default-gatew...