Wireless

Hi.I have a problem.My network - build on WLC 4402 with LAP 1242.Some clients have problem with connect to network - 2 or 3 time in day - for 5-10 minutes. I think that cause by client see 3 LAP with good signal-strength and try to roam from one AP t...

HI, I have an AIR-LAP1242AG AP, I don't understand why they have two RF ports (Left / Primary )for A and B, do you know why ?.

I'm getting this error when I try to downgrade a 1231 from LWAPP to Autonomous mode. The transfer takes place and then it starts extracting file and ends with this message.Any ideas?

Anyone run into any problems running 12.4(10b) on 1310G radios running as P-t-P bridges? I tried 12.4(10b)JA3 and got a really strange asymmetrical association rate; 1Mbps on one side and 54Mbps reported on the other. It ran extremely slow so I downg...

hion my wlc 4404 when i got to wlan>mywlan, i can choose which radios can connect to the wlanlike a, a and g, or b only. i was told by a co-worker that if someone with a b radio connects to the wlan, then the access point will only transmit b from th...

Gurus,My goal is to configure my (2) 1131's the same, with (2) SSID's, one being visible and the other hidden. I would prefer to use the GUI if possible, but can do command line.The visible SSID (named Public) is to have access to Vlan 15 only.Proble...

We have a mix of the AP's with and without Power Injector because only some switches have the POE.On WLC what setting has to be checked on the Advanced Tab for the AP?1. Some times AP gets installed with POI and after couple of weeks the radios go do...

Good evening everyone. I have a requirement for wireless access in our state offices. There are all over Wide Area Links frac T-1 to T-3's. The requirement is for AES using EAP-FAST. The wireless users must be able to work if the WAN link goes down. ...

Hi all, I have wireless network with Wireless Lan Controller 2100 and Light Weight Access Point 1300.All thing run well.But when we need some change on network, i changed IP of LAP 1300 to incorrect IP address. So it can not communicate with Wireless...

I have an AccessPoint (Cisco 1242) that has no Ethernet connection available.Is it possible to use one 802.11a interface of the neighbor Access Point as bridge so that the Access point without Ethernet connection can get a connection?

I have an AccessPoint (Cisco 1242) that has no Ethernet connection available.Is it possible to use one 802.11a interface of the neighbor Access Point as bridge so that the Access point without Ethernet connection can get a connection?

I have an AccessPoint (Cisco 1242) that has no Ethernet connection available.Is it possible to use one 802.11a interface of the neighbor Access Point as bridge so that the Access point without Ethernet connection can get a connection?

Hello All, Has any one good good reference meterial on how to deploy In-Band - Virtual NAC Gateway for Non Meshed Wireless ??