Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I have noticed that from version 4.2x the controller does not seem to pass appletalk traffic through to the wireless clients.I started to look around for some information but there are quite few resources for the 526. So i started to read the release...
I am trying to setup 2 SSID for my APs. I would like to have one with WPA-PSK and w/tkip encryption and also an open SSID w/no encryption.I have looked at the online procedure but there seems to be some missing information or items that I just don't ...
Hi dear expertsI want to connect to locations using 1841 routers with HWIC-3G-GSM cards.Is it possible I use this without connecting to GPRS and without using a profile and dierectly with AT commands?How can I force one router to act in answer mode?H...
my customer had raised a request, they wanted to know if there's any software or simple configuration in the WINXP laptop to do an automatic switch between wireless and wired card. For example, if the laptop is put on the dock, then the wireless card...
Hi,I don't know exactly the difference between outdoor AP with external antenna and Mesh 1520.I want to create hotspot (only outdoor) for a little Park (1200 feet x 600 feet).What is the best design : Severals AP or MESH 1520 ?If Mesh 1520, how can i...
Hi, I am having a wireless LAN controller AIR-WLC4404-100-K9 with IOS 4.0.217.0.with in the LAN I am having 10 LWAP AIR-LAP1131AG-A-K9 they are working fine I am able to access them at any time but, I am having a problem with this (AIR-LAP1131AG-A-K9...
I have two sites, one in England, one in Houston. The site in England has a 4404(10.160.104.187), running against an anchor controller in Houston (10.32.210.251), thatprovides internet access for guest users, running 4.2.112.0. Up until the last few ...
I have a newly deployed WCS/WLC (versions 4.2.97.9 and 4.2.130.0 respectively) and have set up a guest WLAN that requires authentication via guest accounts created via the lobby ambassador. This morning I did a test to see if a single account can be ...
I purchased a light weight 1242AG AP (AIR-LAP242AG-A-K9) when I should have purchased the autonomous IOS version (AIR-AP1242AG-A-K9). I know I can load a previous version IOS with a TFTP server. How do I acquire an IOS release 12.3(7)JA or earlier?
Hi guys!I've heard that "high" gain antennas shouldnt be used in diversity configuration (antennas like 1728), is this true? Also.. while using this antenna, I dont see much difference in coverage than using the regular 2.2 dBi antennas that comes wi...
Hi, Is it possible to have a single SSID on the wireless network but when the users associate to the Wlan them have access to different Vlans?It will be implemented with a WLC (Wireless Lan Controller) and a Cisco secure ACS.
We have a WLC connected to a 6500 Switch, when tried to enable LAG the connectivity goes down, the switch can't ping the controller nor the controller to the switch, we check tha cables, the minigybics, we changed them for new ones,the status of the ...
Hi guys,i need to set ip my wlc as a local eap authenticator.I create a new Wlan(test1) ad associated yo a dynamic interface.layer 2 security--->wpa+wpa2+auth(802.1x)aa server-->local eapI created a local-eap profile where i checked PEAPI create a lo...
Can somebody tell me if this Acess Point, AIR-LAP1522AG-E-K9, work only with one antenna of 2.4GHz? Because in the configuration tool we are obligated to choose three but i only need one. Do i have to buy the three or can i buy one spare? Please help...
Hy there,I've set up a gest SSID using WLC 4400. Everything works as expected, but my costumer requested to block access to this SSID to corporate laptops.I guess it could only be done by MAC Address filtering, but this is not a very good solution be...
