Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Dear AllHow do I connect one Aironet 1300 Series Wireless bridge to Wireless Lan controller 2006?I tried to do the following, but it didn't work!lwapp ap ip address 10.10.10.2 255.255.255.248 (it doesn't accept this commands!!!)lwapp ip default-gatew...
This is quite the head scratcher. I have installed about 7 AP's that pulled a DHCP address from a scope that (accidentally) had no DHCP option 43 associated to it.It is my impression this should not of worked. The LWAPP firmware is 4.0.179.11but is f...
The AP restarts every 30 seconds...just like the documentation says it will!! This AP will not have full capability in LWAPP mode so I need to be able to get it to Autonomous mode but cannot get it from rebooting..... What is the process to get into...
I have very stupidly removed the admin account on a WS-C3750G-24WS-S25's WLC. Is there any way of accessing the device without having to reset it to factory default settings? It's a production device and I could do without having to re-configure th...
On of the Detection way which LWAP use it to know WLC if they are in different subnet is DNS,How I configure this, please?
Need to know whether there is a limitation for faxing or dialing up a modem that is connected via VoIP Trunks when those trunks communicate on a Aironet 1410.. Good voice between the two, but can't access a modem that is connected to the remote end....
Has anybody installed this? I tried but never could get the WCS service nor Apache server to start. Went back to version 4.1.83 and it started fine.
Hi All, I am looking for the explanation of increasing Registration request error - No resources (code 130) on HA. In rfc3220 I find only 130 - insufficient resources. No any other explanation on cisco CCO or web.Thank jm.,
Are there any deployment guides for deploying wireless A/B/G in a multi-story building?Thanks!
I have a Aironet 1200 that was working fine with POE but after the switch was rebooted it won't give wireless. It boots up and I am able to console in to it without any problems. The line tested fine and the switch port isn't shut down or anything. A...
When I go to login to my controller I get a certificate warning. How can I get rid of this?Also, how can I see what version of software I am running on the controller and what version should I be running?Thanks.
I have 4 1410 bridges in a point to multipoint configuration. I have 1 root ridge and 3 non-root bridges. The 3 non-root bridges are associated with the root bridge; however I cannot ping or pass any traffic over the wireless interfaces. Any sugges...
I have 4 1410 bridges in a point to multipoint configuration. I have 1 root ridge and 3 non-root bridges. The 3 non-root bridges are associated with the root bridge; however I cannot ping or pass any traffic over the wireless interfaces. Any sugges...
I am running a bridge from a 1231g with a yagi antenna to a 1310g with the built in antenna. The distance is only about 400?. I have a security camera on the Ethernet port of the 1310. The problem I am running into is that we lose the video from the ...
hi, if any one had implemented EAP-TTLS as secuirty between clients and wireless devices, then pl help me in configring. And what are the security devices required RegardsSrihari
