Wireless

I have many lightweight APs 1231 and I want to install a WLC in the network. My APs may be lightweight. How can I convert this APs to LWAP?Thanks.

we have a 1240 access point on our speed test we are getting only about 13MB when we should get around 30MB my vendor is telling me thats becuase the radio only works on half duplex is that correct??

Is it posible to create a point to multipoint wireless bridge where remote location are on different networks.Currently I have a wireless bridge for one customer (ssid a), now I need to add another customer to the root. I think to make trunk (2 vlans...

LAP1131 on WLC4404 V5.0.148,the radio is down always.I try to enable it but I will get "error enabling the admin status".But it is works fine on WLC V4.2.130

We are using two WLC 4400 Series Controller for our Guest WLAN. They are installed the way Cisco Recommends . One in our LAN and one in the DMZ.I am looking for a possibility to deny company users the access to this WLAN with their notebooks. The WLA...

I started upgrading my 1131 IOS Access Points from 12.3(8) JEC to 12.4(10b)JA3. When I did, I was unable to use Firefox to web admin them. IE 7 still works, but not FireFox. The screen look ok, but the data is not being populated correctly. Anyone se...

Hi allCan any one let me know how to change password of WCS.Thanks for urgent reply

What is the best practice to use when configuring port channel between Catalystr 3750G switch stack and WLC 4402 / 4404 Wireless Lan Controllers:a) Negotiate to LACPb) Negotiate to PAgPor c) Hard-code to Port Channel without any negotiation.Any point...

I have 8 Cisco 1230AP's providing access to my LAN for laptop users. The encryption is via WPA. I now need to setup unencrypted access to the internet for guests/visitors - keeping them away from my LAN and internal network. How can I do this? Do I j...

I have a network that consists of 5 1310 bridges. One is in Root+AP mode and servers as the central node that all others talk to. Today all of the bridges are open with a single hidden SSID. I would like to begin migrating these to WPA encryption. I ...

Hi There,I just have one CiscoSecure for both Web Auth and 802.1x.When working with WLC, how can we distinguish the user that is logged in by Web Auth or 802.1x?Thank you.

Hi all,Can wireless client associate AP by existing loading of AP but not by wireless signal strength?Thanks & Regards,Eric

Hello, I've got a cisco 1240AG K9 AP plugged into a DSL router. It has a factory config with DHCP enabled and one SSID. This AP is set up for open, unsecure internet access in our dining areas. Problem is, I have office PCs in the vicinity jumping on...

HelloI tried to alter the vlan configuration for the management interface on 4402 controller. The management interface are tagged with the vlan 55.Now, I d'like to change this vlan 55 definition to a untagged configuration. On the corresponding switc...