Wireless

Hi,I currently installed a AP1242AG this was to served about 20 users on one floor. But now users located on 3 other floors are looking to use wireless. Could someone provide the best solution to accomplish this.Thanks,Steve.

Dear Support,Tried to configure another AP for one of our offices, currently they have an unsecure guest WLAN, and the aim was to add another AP and configure both AP's (one 1120 and a 1231) for two WLANs, one being secure with authentication via an ...

We have some 7920's that are successfully authenticating to an AP (LEAP with rotating WEP keys) but never get a DHCP address. DHCP server is a router on the same subnet and running DHCP debugs on it we don't see any evidence of the phones requesting ...

Hi,allWhat is the meaning of "hotspot" in the terms of wireless?Respects!

I have successfully setup a pair of 1310s in the past as a wireless bridge. I have another pair I want to repeat this with, but I cannot get this set to associate.I have tried other suggestions, and followed the setup directions in this link: http:/...

Help Please. We have been trying to get a new WLC4400 and LAP1121Gs to hand out IP addresses to wireless clients. Here is the network layout.-Win2003 DHCP server is X.X.64.2 (64 subnet)-DHCP relay is setup on X.X.80.x subnet and current wireless clie...

Hey guys, How hot does the bottom surface get for the 1240 series access point? Does it really get hot enough to burn if left on for a long period of time?-Dave

Is it possible to configure a separate LAP on the WiSM and have it filter clients either by MAC address or limiting the number of clients that are allowed to join it? We don't want the entire network to be filtered this way, just this single AP.

I have a laptop with a 2915ABG wireless card and am trying to connect to a Cisco access point using WPA-PSK. I have tried upgrading the drivers to the latest version but the laptop will never get an IP address. I have a Trend wireless router and thi...

Short of locking down every network port on my LAN I am looking for a solution to detect unauthorized Wireless Access Points (i.e. Home Wireless Routers) from being connected to the LAN.ThanksSigh

My Access Point is running the ios: 12.3(8)JEA and the boat loader version is: 12.2(8)JA.I need to configure the Access Point with Proxy Mobile IP. In conf t mode, the ip ? command does not show any proxy-mobile command.In the http setup page, the se...

I have a 6 meg DSL circuit feeding an AP350 access point. Sitting next to the AP, I only get 3 megs of throughput. Any ideas why? AP is set to 11 mips, 128 bit wep, running V12.05. I'm less than 3 feet from it, so range is not the issue. Thanks,...

Hi!I have a Cisco857 and a Linksys WRT54GL. I would like to set up a WDS link between them.Does somebody know if is possible? If yes, could I find documentacion about it?Thank you,Enrique.

I'd appreciate an explanation of all the software version reported by the WiSM,Below are all I can find.It involves a WiSM with 1131AG AP (converted from autonomous to LWAPP).S/W Version ............. 4.0.179.8 (obvious)Boot Version ............ 12...