Wireless

HelloMy WLSE started a few days ago to give me this error:IP Name Family Product Type SpoofClient SpoofIndex SpoofStaMacAddress SpoofUserId 172.16.101.10 WDS-101.hsr.ch Aironet AP 1210 MAC_spoof 21 0012f066d89f 21 Name State Severity Description Clie...

Not long ago I search some non wireless information and I found some document on Cisco WEB, which say about LWAP to WCotroller communication sensitivity and minimal troughput requirement. There was an info about "serial" line BW bandwidth/speed requi...

Hello networkers!I know the AP goes through a series of steps to discover a controller. I've read that it checks DHCP Option 43 **BEFORE** checking DNS for CISCO-LWAPP-CONTROLLER.localdomain. And, the AP compiles a list of candidate controllers.My qu...

If Anyone knows multissid for Cisco 1100 and can help me ?My Cisco 1100 configuration is :No vlan,Only one ssid, wep mandatory with encryption key in 128.=> Now :I have to add a ssid wpa-psk (but I have to keep the wep ssid) and this wpa ssid will ha...

how to upgrade firmware on 7921g wireless phone from 1.0.2 to 1.0.4 via USB?The 7921g is connected via USB to a PC. I am using a browser to access the phone. Documentation says "Click the Phone Upgrade hyperlink under SYSTEM options. " but that optio...

Hello, I must configure a Cisco Aironet 1100 : Here is the first configuration : no vlan with 128 key WEP. I keep this configuration in wep (no associated with a vlan) for the moment.Now I have to create a vlan associated with wpa-psk with simple con...

Does anyone know if OEM Airespace APs (Airespace 1200)are compatiable with code 4.1 or higher on a Cisco 4400 WLC?

I am running a 4402 controller, wireless location device and WCS. I have setup a Guest Vlan that is restricted with a ACL. Is there a way to restrict / turn off the Guest Vlan during certain hours of the day? Either through the WCS, controller or our...

Hi All,Our WCS has been deployed and running for more than a year. Recently we have added more controllers (4 X 4404) to be monitored by the WCS. The WCS is running 4.1.91.0 on RHEL 4 update 1. The WLCs are running 4.1.185. We noticed on the Network ...

I am trying to set up a Aironet 1100. I enter the mac addr. into the IPSU and get a error - device does not answer. I've reset the device, ng. Tried 2 different computers, ng. I cannot get to the config. page. Any ideas?

Hi,we are currently implementing Cisco ACS Self Signed certificate, for PEAP-MSChapv2 Wireless Access, where we have our Cisco ACS linked to the Microsoft Active Directory. So, we are distributing the Certificates through GPO's.What can be the risks,...

Guys,I cannot figure out how to enable management over dynamic interfaces on a wlc 526. I can find the management over wireless on the GUI but not the option to enable the above mentioned one. If I try by CLI the only option after "config" is "advanc...