Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

We have a site with couple of consumer level bridged AP's. We have been recommended a Cisco 1410 wireless bridge but it is very expensive. What are the added features of this bridge and is someone using it? We originally were thinking of replacing th...

vrushali06 by • Frequent Visitor
  • 915 Views
  • 1 replies
  • 0 Helpful votes

I am attempting to upgrade 41 cisco aironet 1242AG access points. I am receiving a timeout error and no data is being transmitted. We are upgrading from 12.3(8)JA2 to 12.4(10b)JA1. We are using Air Fortress as our wireless auth. appliance. What I've ...

I would like to know what is the difference between the Wireless Lan Controller and the Wireless Controller System.Need I WLC if I want deploy WCS.Can I use WCS without Wireless LAN Controllers?. What is the diference between WCS and WCS Navigator?

I configured a WLC 2000 with one WLAN using the management interface as access to the wireless. I am using a ASA 5505 as my DHCP server. The management interface is using port 4 to connect to port 7 on my ASA 5505. I am able to authencitcate and asso...

gomeso by • Community Member
  • 807 Views
  • 2 replies
  • 0 Helpful votes

I received the following alarm in WCS:An Alert of Category AP is generated with severity 1 by Radio REY_1242AP_LWAP08/1 . The message of the alert is AP '00:19:a9:7b:17:70' with protocol '802.11a' on Controller '10.253.1.7' is contained as a Rogue pr...

bmarms by • Level 3
  • 708 Views
  • 1 replies
  • 0 Helpful votes

Hi,A Chokepoint counts as an LWAP Access Points on the WLCs? I mean if I had a WLC with limitation of 50 LWAP, and my installation has 10 Chokepoints, Is it limited to install only 40 LWAP?I 've only found a limitation on the number RFID Tags dependi...

abayo by • Frequent Visitor
  • 719 Views
  • 1 replies
  • 0 Helpful votes

HI All, I am facing an issue with 7613 series router. When I do show run then its taking to long to display the output of command & at the same time cpu goes upto 85% to 90% & goes down after few seconds. Its happening with both the 7613 switches. I ...

I am trying to place my LAP on a different subnet as of my WLC, this is the error msg i gotReceived LWAPP DISCOVERY REQUEST from AP 00:0b:85:64:cc:90 to ff:ff:ff:ff:ff:ff on port '4'Received a Discovery-Request on an unsupported VLAN 18Did i miss any...

Review Cisco Networking for a $25 gift card