Wireless

I am getting ready to do a conversion from Autonomous/WLSM/WLSE to Lwapp and would like to know if there is a way to load the names of the AP's in the Lwapp controller or WCS. Currently I use the auto config CSV infomation in the WLSE to config the s...

I have purchase the ssl certificate from GeoTrust. Now I am about to renerate the Certificate Request and send it to them. There are tons of document on how to generate that on a Windows machine, but I don't know how to get this info out from ASA. Pl...

Hi !I have a strange problem after upgrading from 12.3.11.JA1 to 12.4(3g)JA1 :!interface Dot11Radio0 channel 2437When I write and reload the ap, thenthe channel I configure is gone and the ap doesn't choose the correct frequency.Anybody else also see...

We have a 4402 connected through a 3750 with ints as follows:ap-manager/untagged/192.168.1.241/yesmanagement/untagged/192.168.1.244/ns.p./na/172.16.0.1/nv/na/1.1.1.1/nwireless/100/10.10.0.1/nInternal DHCP Server enabled at 192.168.1.241In viewing the...

Hi,what's the best way to debug PEAP authentication on an Access Point?we are having some troubles with authentication, and we have Cisco AP's, going into Cisco ACS, which then validates against AD.ThanksJorge

Hi,we are having a configuration in our Access Points, which I would like to know if can create troubles, because in some AP's it works perfectly, in some others we are having issues with PEAP auth.We have TACACS+ for the Telnet into the AP's, Mac Au...

How can I get a list of the oid's that are subordinate to 1.3.6.1.4.1.9.1.507?I need to know how to control these AP's with SNMP for a large deployment and I need specific controls. Thanks Websniper

So I have an AP configured to use a radius server for eap-tls the CA and Radius server are MS CA and MS IAS clients are XPpro. Everything is working fine. So where my question is the cracking of a WEP(128bit encryption). Could someone be in the area ...

My building is about 70 years old and made of block and concrete. Like a hospital or a school.We have two hallways that run parrallel and are about 100 feet long, and are about 40 ft apart with a corridor that connects them to for basically an H. Und...

Hi All,We use cisco 1130AG AP's in our enviroment. (both autonomous configs and LWAPP). For wireless survey's and simulated designs, I use fluke's "InterpretAir". I have noticed a couple annoying things. the options for wall structures are very limit...

Is a dedicated controller in DMZ really required for Guest Access?I haven't found a wealth of justification for a dedicated controller in DMZ for a location which has only 3 APs. What is the risk level of directly attaching a port on a 4400 controlle...

I have a WLAN controller at HQ and want to put APs at my branch offices, but connected and managed by my controller at HQ. I know that if the WAN goes down, I will lose wireless, etc.my question is:Is there anything I should watch out for with this t...

hi, i hv a wireless IP phone,AP, 2960 switch1 and another 2960 switch2. My question is, if i configured voice vlans on th access ports on th switch1 (for voice and data), this switch1 is connected to the AP and the IP phone gets connected to the AP s...