Wireless

Hi All,Probably an easy question here.I am just wondering what I should set my Session Timeout (secs) on my SSID's to int the WiSM's? Mine is currently set to 1800secs, but I sort of want to change it to 300 secs so that when people walk out of a par...

Hi, I have WLC with 3 SSID's. 1st SSID is with encryption WPA-PSK, second is with web authentication and third is no security policies. I have primed the AP in the local subnet. The REAP AP managed to find the controller and associate, but only manag...

If I discover a WLC through the WCS, do I still need to manually configure the WCS as an SNMP trap receiver on the WLC?

We're using WCS with controllers, and cisco Access Points. Can anyone tell me why none of our access points are seeing each other as neighbors, in fact they all seem to see each other as rogues.ta

1240,1300,1400 or 1500? or any other type?thanks.

The Utility Ports in the wireless lan controllers, When is used this ports? Which is its proposite?

What is the main function of the service port in the 4400 series WLC?

I've been trying to figure out what Trusted AP Policies and their respective sub-options might be for. Unfortunately, this subject seems to be documented very badly...Can somebody tell me more about it? Does anybody have some of these features activa...

What is the corolation between the BVI interface and the native vlan. I have a bridge that is connected via a trunk port to an 871 router. The router has a couple vlans configured. On the bridge, I have an ip address on BVI1 that is apart of the VLAN...

Hi Guys,We had iinstalled around 4 Cisco Aironet 1232 AG-SK9 that we had convereted to Lightweight WAPs and installed a Cisco Wireless LAN Controller 4402.We had seen that 802.11a is woeking fine in terms of Signal strength, however using 802.11 g gi...

Pardon my ignorance, but I have never worked with an Aironet 1100. The device I encountered is active and connected to an internal network. My objective is to keep the ssid and password the same but relocate to a different site that is connected our ...

I manage both AP 1000 and 1200 series aironet. I want to believe that the smaller the range (coverage) the higher the speed. I can i control the coverage range of each access point. Is it possible to contain it, it is going way out of the range we wa...

HiJust trying to get a P2P WLAN bridge working and on the non-root I get the error %dot11-4-cant-assocand I do not know why.What do I really need configured (SSID? MAC Address etc) for a bridge to non-root bridge constallation to work ?Just now there...