Wireless

I've implemented a 4404 and I've got a number of AP's associated. I've got 1 that went down and I know the MAC but I haven't documented the names. Is there a way to find out what the name of the downed AP is? I can't seem to find the information. I k...

I am having a problem getting hot standby to work. I have two AP1130AG and as far as I can see they have been setup identically.When I turn on Hot Standby it fails to initialise. When I check the log I see the following messages:Warning Interface Dot...

Hi, When running multiple SSIDs on an AP all SSIDs share the available bandwidth. Is there a way to prioritize the traffic?....ie...can I somehow give preference to traffic on SSID A over traffic on SSID B?...thanks in advance.......J

I was wondering if you can use the Cisco LWAP in an eviroment where they will not be mounted and will be moving from room to room through out the day. The controller would be in another building connected by a T1. I was thinking that once they are pr...

Hello,I want to do this configuration:Site A must be connected to site B and to site C. On the site A there is an AP 1230AG, it's configured in bridge mode in point to multipoint to site B and C in 802.11A.On the site B there is an AP 1230AG, it's co...

Can I use other protocol to authentication a BR1310 in bridge mode ?

Hi Experts.. .Is there any way to conevert the lightweight AP (Cisco AIR-LAP1242AG-A-K9 ) to autnonoums ? i have seen an article in cisco to convert autonomous AP to lightweight and backto autonomous. but in my case the AP is lightweight. Please advi...

Hii have a problem with 877w.i have some pc's connected to the fast interfaces and dsl is up and running.pc's can surf ( via nat on the dialer interface ).now , on the wireless part , i configured auth (mac address) and enc + dhcp pool + nat on the d...

One of our office that already has 1 2000 controller needs to install another one. Can the new controller be on the same subnet as the old one or does it have to be on a different subnet?thanks

Hello,It appears that in LWAPP changing the power levels on APs causes their radios to reload. This was not the case with IOS APs.Does anyone know whether modifying RRM DCA (from Auto to On-Demand via WCS Radio Parameters template, holding power leve...

First, I'm not Bilingual so excuse my English. Dear Sirs, Please teach Wireless Control System (WCS). Whether "Windows 2003 Enterprise" is supported from the following evidence is not understood. Is "Windows 2003 Enterprise" supported? Table 3. Produ...

How or where do i set port forwarding, i'm new at this router and don't understand anything.

in first i do my appologie for my basic and simplist english.i have juste one little prob with my power book G4 whit 256 Mo RAm. i install the client utility for aironet 350 - that is ok- reboot - so when i want conf connection. it's very long and th...