Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I have a pix 520 handing out my dchp address in a small remote office due to that they use a cable modem for access to the internet and the dns servers change regularly. If I have no encryption turned on then the laptop associates fine with the AP an...
Does WPA-PSK with TKIP encryption not support MIC?any input is very welcomeOliver
Hi, I have a scenario where aircraft service engineers need to have access to a LAN from inside a stationary aircraft (possibly a Boeing 747). The AP 1200 (a/b/g is required) will mostly likely be mounted on a aircraft docking bridge either at the co...
I use two extenal onmi anntenas at ap1200.But how long limit to fix between two onmi anntenas?Any one can help me !Thanks!
Does anyone know if and when it will be possible to use the 802.11a bridges in Europe?Is that in some way regarding the 802.11h support of the bridges themselves?Thanks in advance.
HiWhere is the option to allow single domain login so that clients just press CTRL ALT DEL and enter their Windows domain credentials. I have read that you can have authentication using the domain credentials but cannot find where on the client this ...
Hello, this is my first threat here I have one question here. I know Cisco 350 supports WEP but does it support WAP as well?? Currently, I am using driver version 2.1 and firmware 4.25.30 in my linux box, sould I download/configure something to make ...
I have my APs (350 & 1200) on Cisco 2950 switches. For the optimal setup, should I have the AP set at 100/Full Duplex? Should I set the port on the switch to 100/Full? Should I have spanning tree 'portfast' set on the port on the switch? Thanks,
I had CCME 3.1 and 100 User Licenses , Do I must buy CP-7920-CH1-K9 , not CP-7920-BUN-ST-K9 ? Any one can help me ! Thanks ! chenmu
This error has recently started to show up in the logs of our closet switches. (3500's and 3550's) It is only associated with clusters that include a powered switch servicing AP1200's. What should I look for? Is it a concern? Thanks Tom
Why do I recieve the following error from WLSE 2.7.1 when scheduling a firmware job to upgrade from 12.2(13)JA2 - 12.2(15)JA? I have no problems upgrading to this image from a command line using a TFTP server. Here is the output I receive from when I...
I configured EAP-TLS for the wireless LAN in the Novell 6 environment. However encountered a problem on the ACS with Novell NDS. Attached is the error messge, any advice on how to overcome ? I have generated the server key and the client key from Win...
I have several Novell 5 & 6 servers running pure IP. All of my Desktops run fine with a wired NIC. All of my XP wireless laptops run fine with either a CISCO 350 wireless card or its own internal NIC. The problem I have is with 2 models of laptops. O...
I use two extenal onmi antenna at ap1200. But how long limit to fix between two onmi antenna? Any one can help me ! Thanks!
Hi there,All leds of my AP turned amber. this means "Boot failure" according to this document: http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_guide_chapter09186a00801cfb52.htmlBut how can I get through it?
