Wireless

I was wondering if the Linksys WET54GS5 Wireless Bridge is compatibility with the Cisco AP1100? Does the WET54GS5 support LEAP?Thanks.

Currently I'm using LEAP for authentication on my AP's at roughly 200 remote locations, with about 6 AP's per site. These are performing local Radius authentication on the AP's themselves. We are using non-dictionary passwords, so I'm not too worried...

Hello EverybodyI'm trying to simulate a routing protocol for a wireless network using OPNet IT GURU Academic Edition but the documentation is very rare. Have anybody done this before? Can it be done? Where can I find extensive documentation about OPN...

On occasion, I recieve the error "Failed to Address Packet from 192.168.1.1 ..." from a few of my BR350 bridges. The Docs say that "A device attempting to authenticate ..." The odd thing is that the "device" in question is just a router, & it is not ...

Hi, I tried to downgrade AP1200 image from c1200-k9w7-mx.122-13.JA1 to c1200-k9w7-mx.122-11.JA1 via TFTP server, got the error message of:"ERROR: Problem installing (renaming) downloaded files" I verified that the flash has the enough space for the t...

hello,i'm going to look for forbidden access points at the ports of huge network. is there any document that can show me whether a mac adress is an access point or not ?

I tried to update the firmware on my AIR-WGB352R to 8.85 and now IPSU can't talk to it. I have it connected directly to a PC. When I try to get the IP address it times out. I talked to Cisco and they say I had the right firmware and they say I have t...

I seem to remember something along the lines that 11i would not be compatible with older access points, due to increased processor requirements for the encryption. Is there info available as to whether 350 access points will be upgradable or not?

We own several properties that are operating in a 50% wireless environment with no issues. However one property continuously drops connections in their most conjested area.Heres the senerio:In a 90m area there are 10 staggered Ciscio 1200 AP's, alter...

I have landed a pretty big WLAN roll out. 75 1231 WAP's and ACS for authencation and Cisco Works with WLAN engine installed. ACS Radius should be the straight forward to configure has anyone run into any gotchas installing it. Cisco Works also should...

Can someone explain to me the technical differences between WPA key management and CCKM key management ? Is CCKM just pre-WPA standard and only works on Cisco cards or is there a difference ?I know CCKM supports fast reassociations but is that the on...

Hi,Can a 350 workgroup bridge get connected to AP 1100 and 1200 series?Will Cisco come out a new model to replace the current workgroup bridge?Thanks.Delon

We have Two sites connected with both fiber and aironet 350 wireless bridge. We installed the wireless bridge to provide backup link when other link goes down, but when we activated the two link in the same time the connection become unstable.we got ...

Hi,I am designing a wireless LAN for customer. It is an end to end Cisco solutions. With CSACS acts as the authentication server. They have a mixture of wireless client such as Cisco and others. For Cisco client, they will be using LEAP / EAP- Fast p...

I have a 1100 Series AP but I don't know the password for it or even know what the IP address that is set on it is. Is there a way to reset it to default configuration and recover the password? Please advise.