Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hellosuppose we have a wireless client using an encryption key with an AP.when a client roams from that AP to an other, how the new AP will learn about the key used by the client.must we configure the same key in both AP? or must we use a local route...
Topography: Two bridge units using 6DB patch antennas across a concrete parking lot, at 100mw input. Near side is attached to 10/100 switch and the rest of the network. Far side is attached to 10mb hub with 6 clients. Radios are reporting high levels...
Hello.We have a test with an ACS 3.2, 1100 AP and run PEAP for authentication. I have read that it is possible to deliver dynamic WEP-keys from the aaa-server to the client but not sure how and how to verify..Setup:ACS with PEAP enabled (works fine)C...
I need solution for following:Wireles LAN clients with various wifi cards - I need authentication on our ACS server /ver 3.2/I dont want install any certificate or software on clients. It looks like job for PEAP but am I right???? I didt find any con...
I'am getting Underrun, Overrun and Missed Errors on one side of my point to point 340 Bridge connection. All I can find is documentation stating that "this occurence is rare" which tells me nothing about what is going on. We tried a different bridge ...
Ok, hit me for not realizing this. The AP350 (and 1200) have their service range for ACK timing hardcoded. I should have used the BR350, but was told it was not avilable in a hardened style when I was purchasing. IS there a way to set this to a large...
Hi i´m trying to install laptops with intel centrino processor and cisco aironet 1100, but i have no conectivity to the network, i just see associated the laptop in the access point but i can´t reach the network, i have cisco wireless lan adapter too...
AP 1200 receives valide IP from DHCP then show 0.0.0.0 on wireless device Airnet utility. This is only happening on 5 of 14 AP's in warehouse enviroment. AP on a fiber network
The goal is to make Wlan more secure. besides all the standard LEAP, MIC & TKIP implementation, what about no DHCP but static IP assignment for each client ?For a case that a smart hacker got into our network and got EAP authenticated. If we don't us...
I want to configure a VLAN through our CISCO AIRONET 1200 Access Point. In order to do this, we have read the Installation and Configuration Guide and we have found that the mechanism includes the assignment the VLAN to an SSID and also the encapsula...
Is SSID broadcast turned off by default on AP1200 IOS. If not how can I turn it off. On the AP1200 VX there is a place you can turn this off but where is it in the IOS version?Thanks,gilbert
Hello,I am running VxWorks ver 12.02 in my 1200 and 350 I have several wireless clients (Compaq multiport, ActionTech USB and Cisco 350 PCI). In the Association table on the AP sometimes the AP deathenticates due to Inactivity. Is there anyway to nev...
