Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

hello i noticed that every time i use the cisco AP350 ((50mW) 2.4G 11Mbps) i have a headache :-((did any one notice the same problem !

Hi,if you install Cisco PEAP supplicant , the MS Supplicant with MSCHAPv2 support will disabled and only Cisco PEAP-GTC is available.Is there any possibility to have both versions available at the same time , so i can select which PEAP method I`d lik...

HelloWe need to run a multicast app over wireless network.Who has some design guide or good paper on this? Any precaution we need to take care?thanks

zhichao by • Level 4
  • 580 Views
  • 2 replies
  • 0 Helpful votes

These are the setup that I have: BBSM---Switch----AP----Wireless ClientAfter wireless client authenticated, if I let it idle without any activity ( meaning not accessing any web site/application), How long will it timeout the connection or it will ne...

ccsam by • Level 3
  • 784 Views
  • 1 replies
  • 0 Helpful votes

I have a BBSM appliance (BBSM 5.2 Build 2.00) with all the service packs up to AccessCodesPatch.exe (Patch 5220).I am trying to transfer and then install patches 5223, 5230, 5232, 5233, and 5239. However, I get the following error message after brows...

j-judd by • Visitor
  • 983 Views
  • 3 replies
  • 0 Helpful votes

I have read a paper that indicates NDIS 5 support is mandatory for adaptors that will be used for Hot Spot access. I don't believe the PCM352 has this - but appears to work in UK HotSpots I have evaluated.Latest wizard, 1.1, says it is installing NDI...

rapepe by • Community Member
  • 677 Views
  • 1 replies
  • 0 Helpful votes

I am having trouble hardcoding ip address, works fine when leaving as dhcp, when i hardcode the bvi1 interface I wont be able to access it any more. I've tried this via web and command line. I need to know what i am missing.

schaufd by • Community Member
  • 803 Views
  • 2 replies
  • 0 Helpful votes

HiI have the following situationRoot BR ------- 8km ---- WGB -----------9km-------- non root bridgeThe P2P link works fine. when i turn on the wgb and i ping the wgb i have many packet lost. and when i ping the root br from my Backbone i have also pa...

Review Cisco Networking for a $25 gift card