Wireless

This may sound rather naive...however, in my pursuit to understand the PHY layer, if a Radio is transmitting at a frequency of 2.4GHz, then this means 2.4 billion sine waves per second. Hmmm...then how come you cannot place a bit on each sine wave an...

Hi all!Is there any way to configure the 1200 Ap not to change to Repeater mode when the Ethernet Connectivity lost.?

Is there a limit of the filtering entry for the Aironet 350 access point?I check almost all the 350 related docs, and can't find anything.regards,Karl

Whats the last supported BR500 firmware and how can I get it?Thanks in advance -Danny

I would like to set up some access points where customers can access the internet. The idea is to give wireless access to outside customers (each of them should have username and password) which has nothing to do with our corporate network. I have an...

I'm using many AP and BR in 2.4GHz for outdoor connections. I saw that the new product Aironet 1200 can be used with 5,7GHz frequency but it does not have a RF connector for an external antenna.Will it be available some day with RF connector ? (like ...

I'm using the AP1100 with multiple vlan's and ssid's. Vlan 1 is the native vlan (same as the switch connected to the AP1100). I don't have an SSID for Vlan1.When I do an active Site Survey with the ACU I get a constant incremental for "Lost to Source...

I want to track bandwidth usage per client. Is there a way to get an MRTG or other type report from the AP's?-Jay

Hello,Does anyone have ideas/examples on using SNMP to query 350 series bridges to obtain running data on signal strength & quality? I would like to use something like MRTG to monitor signal strength, along with link usage.Looking through the MIB fil...

Hello!I'm using Cisco 350 Series Aironet PCI Card in Linux for wireless communication. Till now didn't succed to make the card to work in Infrastructure Mode, just ad-hoc. Installing Linux RedHat 8.0 and using "iwconfig" command I saw that it is poss...

Can anyone tell me what kind of performance hit I would expect by enabling WEP on a point to point wireless link using 340 bridges?

Please provide recommendations for improving throughput on a wireless 350 LAN. Synchronization of the Blackberry PDAs hang over wireless and can take up to 15 minutes to close once the operation is cancelled. I have tried IP protocol filtering but wa...

In Event-Log at one of many BR350, configured as Non-Root w/Clients, there is this warning: "Attempt by ... to Sieze Self IP Address via Proxy ARP to [broadcast]ffffffffffff".On webpage of Event Log for this device there is a link to http://www.cisco...