Wireless

I have a demo WLSE that I upgraded from 1.1 to 1.3. For the many switches it discovered along with APs, it is declaring for each of them : "Switch memory utilization is Degraded (66%)" -or some other percent. Is this a glitch? Anyone else seeing this...

Can the Cisco Aironet 350 run NAT?

Is there a way to change the 350 MiniPCI client MAC address in XP or with the Aironet utilities ?

Hi, my APs are directed to send snmp traps to the netview system. And when a wireless lan user gets onto the lan successfully, the corresponding AP would send a message similar to the following:Thu Dec 12 17:19:05 2002 "APhostname" Trap found with no...

I am getting the following message in the log of a few of our 1200 series access points. Network Bridge Loop: Received packet from Self destined to [AWC Mcast AP-Only]014096ffff00 on port "emac0"What is causing this and what can I do to prevent it fr...

Need Help, I was unable to assoc to AP which firnware 12.00T ot 12.01T with client have this version of firmware 4.25 , What is the meaning of this Require use of Radio Firmware 5.02L yes/no, ThanksRegardsMCNaz-yeo

Will the "Bridge Spacing" feature of the 350 Bridge help in reducing collisions for a 2000 ft radius outdoor Access Point. Any other suggestions to help make this work? We have a central 40 ft high 8db omni antenna and each laptop is using an LMC352 ...

how can I configure certificates (PEAP) on AP350, clients? I need samples the configure

Befor about 9 months I installed 20 sites Linking to 2 Omnis in Diversity mode in a 6km radius and the network was working fine with WEP enabled using 4.25H firmware, when I added 5 more sites (using 4.25G Firmware) the Root bridge started to reboot ...

How can I find a way to use my laptop without all the wire . I want to use it anywhere at home, or on the road and be online

Hi maybe someone knows when TKIP and MIC will be supported on Linux ?all i can found states " Firmware 4.25.30 supports TKIP and MIC but the current Linux driver doesn`t !"Is there any possibility to merge the drivers from airo-linux.sourceforge.net ...

I have 3 buildings with wired LAN (Ethernet) each one.Can I connect the 3 wired LANs with a BRE500 in the main building, a AP340 in other building and a AP340 in other building?It is possible? Why?Thanks

all- when upgrading the firmware to my 350 ap, will the config remain the same or will i need to reconfigure the AP? my intent is to do this remotely via the web browser..... the current is 11.05 and my plan is to upgrade to 12.0T.thanks

I was not sure if this could be done. Is it possible to use the bridge as an AP?

we recently bought a 2 Cisco Wireless Bridge 350. In order to activate the WEP Key does I need to install software inside my wired client PC.