Wireless

Hi everyone,Someone told me about this issue this week. I heard that roaming between APs was not possible without reauthenticating when RADIUS authentication is used. This means that you need to reauthenticate yourself to the RADIUS server each time ...

Win 98 PC with 350 PCI card, 4.25 firmware, 8.2.3 drivers, ACU 5.02.005. Attempting to use LEAP with saved username and passwordagainst the local database on ACS 2.6 via AP340 11.10T 802.x draft 10. The PC boots, username and password for NT domain s...

Looking for a good commercial (not homemade) solution to reflect signals around obstructions. I do not have point to point line of sight, but have a third location that does have LOS to each site.Planning to use BR350s at each site.Thank you.

Hello,I´d like to roll out an WLAN Netwwork with 4 1200 AP / 1 x W2K Server / 18 x XP PRO. The security with WEP encryption is to weak. So I´m looking for a solution. Can I get high security with only W2K and XP Pro or do I need the Cisco Secure ACS ...

Will it be any interference to the wireless radio signal by a satellite TV dish (vsat) ?Thanks.

I have 3 repeaters connected to 1 AP ( as root). All unit are using same SSID, different radio channels. Other settings are default.However, all repeaters are intermittently associated & disassociated with the parent AP, at least every 2 minute. What...

I used this link to help me configure the ACS and the Cisco 350 Access Point.http://www.cisco.com/warp/public/cc/pd/witc/ao1200ap/prodlit/wrsec_an.htmAll I want to do is to only allow certain MAC address to associate with the Access Point. No LEAP or...

Hi all,i have a big problem.well, i have 3 cisco aironet 350 series and i lost password.how to recovery my password ??? the version of used software in these bridges is Aironet BR500E V8.24please, help me !!!!!tks...

Can anyone tell me if WLAN is usefull at remote locations ? I could not understand the limitations interms of distances... miles/meters etc.. Thanks,

I noticed that there are two differnt types of workgroup bridges. They are:AIR-WGB352C: One nonremovable 2.2-dBi dipole antenna included AIR-WGB352R: Two RP-TNC connectors (antennas optional, none supplied with unit) What type of application would de...

Cannot even connect via hyperterminal with required settings. Plugging in with ethernet doesn't do anything either except I get a blinking light on the switch. Never any light on the device.

I have been running couple of 350 bridges for about a year now. My firmware is at 11.23T. I am looking for information, hopefully a step by step, to enable the highest level of encryption / security that I can.I am running these in bridge mode betwee...

We started a video conference from a wireless workstation - a Cisco 350 client associated with a Cisco 350 Access Point.We successfully transmitted video and audio from the wireless to the other station on a different ip network, but we were unable t...

Is it possible to connect a AIR-LMC352 to an AIR-ANT3549 and if so what part or manuf. cable would you use to conenct the MMCX on the card to the RP-TNC connector on the antenna?My hope is to use this to communicate back to a 350 Series bridge in AP ...

Hi everyoneWe are looking at the possible creation of a "video only" network for the transport of our clients H.323 videoconferencing traffic throughout our community. Does anyone have any experience transporting H.323 video over wireless networks? A...