Wireless

can lightning arrestor handle a direct lightning strike and discharge this energy to a properly installed earth ground?

what's the relation between Gain and transmitted power with coverage area?if we want add coverage area, could we just add antenna's gain only or add transmitted power only?

can lightning arrestor handle a direct lightning strike and discharge this energy to a properly installed earth ground?

I would like to know if you have any issues of signal problems of the Aironet Solution with any wireless telephone system usig the 2.4 GHz bandwith.And if you have seen any problems can we use the 5GHz equipment in Mexico

helloif we use aironet access point, is it necessary to have cisco wireless NIC? can we use wireless NIC of an other company (3COM, SMC,...)

Has anyone found problems (dropped packets, etc) with clients running terminal emulators over a 350 Bridge-to-Bridge connection?I'm getting people 'kicked' from their terminal sessions, yet the network is running perfectly. I have adjusted the Frag T...

Hello,I wanted to know whether we can configure WEP encryption between the access points and the third part client cards .Thanks.

I am studying for the Wireless LAN Specialization. I have gone through the on-line web seminars. What I would like to know is how do I judge when I am ready to take the test. Is there anyone out there that can give me a topical list of what is covere...

How to fix the problem where the peripheral equpment A/B switches indicate the opposite of the Active Side on the VCO.

How to fix the problem where the peripheral equpment A/B switches indicate the opposite of the Active Side on the VCO.

Hello all, this is my first time creating a thread and hope someone can help. We have a current setup using WGB340's. The bridges are running point-to-multipoint, three of them going to one at the lan, and no-one authenticating to them with laptops o...

When assigning an IP address to an access point it has to be on the same network as the clients that are associating to it, correct? For example, if my clients are on a 192.168.0.0 private network, can I assign a 10.0.0.0 address to my access point? ...

Hi,Can someone advise how many simultaneous users can the Aironet 350 support? And, how many users is it supported to run encryption and network authentication?Thanks in advance for all the kind replies.

Any who can explain me how this thing works actually , i mean to say why we have to select"Select "NO" for the Adopt Primary Port Identity option in the AP Radio row under Network Ports.Actually i am setting this feature in my lab for the customer an...

Is there a way to run mobile ip without a special client? I looked at several white papers and didn't see anything about a special client until after I called the TAC. Any thoughts?