Wireless

Is this possible within the AP itself.I would like to be able to secure access between clients on the same access point. Is this possible.? I don't want to have to do any type of VPN.There will about 10 users per access point and there is a need to s...

Hello, i am very confused, its possible to setup the AP350 (11.21) to only associate with specified MAC addresses and block all others ??When i set up a Mac filter only the dissallowed rules work - why ? what i doing wrong, any help would be apprecia...

Hello Eric,I currently have an Cisco Aironet Wireless AP, which was disconnected from a network that no longer exists. When this AP was connected to the network, it was configured with two addresses for ACS Authentication servers. Unfortunately, thes...

If I am using 128bit WEP and enable the TKIP and MIC features on the AP and clients -- what sorts of attacks am I still suscpetible to? Take for granted that the people using the gear are who they are supposed to be, etc -- I am most interested in wh...

Hello, i am a bit confused, how i can upgrade the Radiofirmware of an AP350 ? the installed version is 4.25a, I use System Firmware: 11.21. Where to get the file for the RadioFirmware ?Why my AP350 shows the following @boottime : h) FLASH :340 Series...

Can a Aironet 340 Bridge be turned into/used as a 340 Access Point?Can I just change a setting and switch into AP mode vs. Bridging mode? Or can I load up the AP firmware on the 340 bridge?Thanks,

In my world the Cisco Aironet 350 things are being used as bridges - simply replacing slow APL-lines. As so, I realy hate the menu-based setup on these boxes. An IOS-like command line is far preferable as I'm able to generate a configuration and now ...

Hi We currently have a campus wide switched network consisting of Cisco 6500 and 5000 series catalyst switches in the core feeding 1900 series catalyst switches at the edge.We use DHCP and VMPS to determine IP address and VLAN information for each ho...

I'm using an Aironet 350 AP with 11.21 firmware and tring to apply an IPX filter on the radio side of the AP. I created the IPX filter using 0x8137 and 0x8138 ipx protocol and set the disposition to block, but when I apply the filter to TX and RX on ...

Can somebidy please recormmend an appropriate cisco wireless base station / access point that would function perfectly with CISCO AIRONET 340 series .

What is the upward limit to the amount of IPX traffic you can filter using an AP350.

I admit: I don't use RADIUS! I've got many (in my opinion) good reasons why not - I won't bother you with that.I configure my BR350 with static 128 bit keys as they're supposed to link two LANs. I tell those boxes to expire the key at some time and e...

Has anyone ever received this message?Warning: BKey1Proc radio dev802_11END_c.Anyone know what the means??Thanks,

Installed aironet 350 on IPAQ, current drivers. Associates with AP340 & DHCP states IP given (verified by mac). still cannot access anything from IPAQ (IE) or mail. No ping to test connectivity? Am I missing something or will Aironet 350 not work wit...

Im thoroughly confused.Please help.What I would like to do is setup my clients to useEAP LEAP first whats the difference.Do I really need the ACS? I have a radius server already. If so why do I need the ACS.When I am setting up the Wireless Access po...