Wireless

I have one wireless bridge going to only one point, but the users are using up the bandwith. I need to get more some how. I would like to set up another point-to-point link, but I dont want to have spanning tree loops. Is there a way to get this done...

How do you turn on TKIP and MIC? I am running 11.10t firmware on the AP's.

Hi,I'm trying to understand the specific differences between the 340 & 350 bridges. We currently have (3) 340 Bridges installed which perform flawlessly. We're being told by our home office that we need to install 350s for security purposes. I'd like...

Hello,My configuration is:PCI cisco card -> AP340 <-> AP340 (repeater) <-> PCI cisco cardI read all of the manual and can not make the repeater to associate with the AP340Is there something special in the configuration ?Regards,Todor Neshev

Greetings,I would like to find out how then can we from the "AP Radio Port" page from the statistics displayed, determine if the AP is performing well. For example, how high should the PLCP CRC error or the PLCP Format error to constitute a bad perfo...

MY 2610 router had 5 serial line protocols down. My telcomms company has verified that all the lines are ok. One of the interfaces now is up. I dont know how I can debug the router to check what the problem may be. If I use the clear interface comman...

I am interested in either the Aironet 340 or 350. The only difference I can seem to find is the 350 is a higher powered AP. Is this the only major difference?I am interested in a SOHO setup and my office is in a converted garage. I need to share the ...

Has anybody managed the Aironet 350 APs using CiscoWorks 2000? If so, what can you tell me. I have doubts about if you can do more things using CW2000 than if you are using HP OV. Of course if you want to manage CISCO switches the CW2000 gives you mu...

When using LEAP and Cisco ACS, is the client's password stored as a hash in the Cisco ACS RADIUS server or stored in the server in a RADIUS format? The reason I ask is that we are trying to understand if mutual authentication between client and RADIU...

Have a 340BS with encryption. Unable to obtain an address from MS DNS server through BS. wWhen I disable encryption, address is obtained. Any suggestions.

I'm using an AP350 device and LEAP. Throughout the day, about every 10 minutes, I get the following error in the access point. During this time, I can't access the LAN unless I stop and re-start LEAP on my client but I can ping the AP device from the...

Is Leap supported on a point to point bridge connection within the 350?

Can anyone point me to a link that talks about how to setup roaming with AP350's. Right now the clients has to drop completely before connecting to the AP that's nearest to it. From what I've seen on some of these boards it has to do with changing th...

If anyone can help with this it would be great. I have a 350 AP w/ 11.10 firmware running LEAP, i have a couple 350 workgroup bridges that authenticate with it just fine, but i have a win98 client w/ a 350 pci card in it that will not authenticate. t...

We have upgraded the IOS on Cisco 2924 switch, configured it for Tacacs, however the visual switch management using Netscape for the above switch doesn't work. Any ideas?