10-18-2023 04:08 PM
hi,
as above, the HA was setup in 1G transceiver. Now, customer will like to upgrade to 10G.
but the HA unit is using the same config file and the interface config was set "negotiation auto" to detect the 1G transceiver.>> need to change to "no negotiation auto"
IS there a way to TO CHANGE THE traceivers to 10G w/o bringing down both of the units?
thanks.
Solved! Go to Solution.
10-19-2023 12:08 AM
>....note the issue is the HA is running on the same config file. so i cannot change the spare unit to 10G transceiver uplink..
(OK , not RP = understood) That is a showstopper because in HA , everything must be completely symmetrical.
M.
10-19-2023 12:12 AM
hi, i am talk abt the 4x 10G data ports
You can not manually change any configuration on the standby.
My suggestion is break the HA - configure on Active Until the changes for 10GB, and on the Standby by just configured required configuration to join HA - so all the configuration will be synched to Standby.
10-18-2023 11:44 PM
- Note that the redundancy port only supports 1G (fiber) ; you can change one box to 10G (when the other box is down) , but not when the HA is online, so it's not possible without disruption ,
M.
10-18-2023 11:53 PM
hi, i am talk abt the 4x 10G data ports, not the RP port.
Do u understand wat i trying to say?
previous we dont have 10G switch, that why on the C9800 i configure "negotiate auto" command to detect the 1Gb transceiver.
note the issue is the HA is running on the same config file. so i cannot change the spare unit to 10G transciever uplink..
any one..
10-19-2023 12:08 AM
>....note the issue is the HA is running on the same config file. so i cannot change the spare unit to 10G transceiver uplink..
(OK , not RP = understood) That is a showstopper because in HA , everything must be completely symmetrical.
M.
10-19-2023 12:12 AM
hi, i am talk abt the 4x 10G data ports
You can not manually change any configuration on the standby.
My suggestion is break the HA - configure on Active Until the changes for 10GB, and on the Standby by just configured required configuration to join HA - so all the configuration will be synched to Standby.
10-18-2023 11:50 PM
RP Support both Ethernet and SFP ports - depends on the model you can find information in HA guide :
IS there a way to TO CHANGE THE traceivers to 10G w/o bringing down both of the units?
best is bring down the Standby Controller to Offline and change the SFP and bring back Standby controller once RP Port up and working.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide