02-23-2022 05:08 AM
Hi Team,
I have Cisco Air1832 AP below are the image
AP Running Image: 8.5.140.0
Primary Boot Image: 8.5.140.0
Backup Boot Image : 0.0.0.0
I have created a WLC image is AIR-AP1830-K9-8-10-151-0
After that, I have able to access GUI and AP also configured.. But the client do some changes after that unable to access or ping this IP I have config another Ip and the save management IP is showing under cisco controller > but unable to access or PIng this IP .. assign System IP in 192.168.0.X/24 scope.
WLC ip is 192.168.0.254/24 Gateway 192.168.01
I have reset the cisco controller>reset the system but the configuration is there
How to reset controller config through CLI or please share troubleshooting steps.
Can some guide and share the proper link of the configuration and troubleshooting.
02-23-2022 05:33 AM - edited 02-23-2022 05:33 AM
To completely reset the AP you need to power it off, press and hold the mode button and then plug it back into power. Hold the mode button for around 25 seconds, until the LED starts blinking red, then stop holding it. If you have a console cable attached, you'll see the message about the reset and it's a bit easier for the correct timing.
This will completely factory reset the AP and controller.
02-23-2022 07:03 AM
Dear Sir,
After resetting of AP the controller, then I need to do a copy from TFTP and reinstall the controller step up..
There is no VLAN then I need to set 1 Vlan or no VLAN Please guide
02-23-2022 07:09 AM
Please follow the guide below. Anytime you factory reset an access point, you will need to configure it from scratch. The deployment guide walks you through what you need to do. It's easier to follow this step by step. You can even search the internet for "Cisco mobility express configuration" and look at some blogs or videos.
Cisco Mobility Express Deployment Guide - Cisco
02-23-2022 08:30 AM
I would suggest to re-configure the management interface IP and the gateway.
config interface address management <IP address> <netmask> <gateway>
Also check whether there is any duplicate IP in the network.
02-23-2022 08:52 AM
Yes sir I was do this step 2 times there is no duplicate IP in network..
but unable to ping or access WLC management IP any other troubleshooting step can you suggest to avoid reset the device
02-23-2022 09:00 AM
Why not reset it? If you spend hours or day's trying to get it to work how it is and never really get it fixed, resetting will get you there faster or provide more info on what is happening. If it happens a second time, it can be a bug or something you are doing wrong.
02-25-2022 01:13 AM
Hi Team,
I was re configure Controller IP address ,Reset AP point reconfigured but no progress then i was replace switch (IDlink DGS-F1010P-E) connect Netgear Switch after that its working withing minute ,Dlink switch is ok but don't understand why its not working and support to this switch.........But issue resolved. any idea ..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide