CLI Command for CW9166 Access Point

[madhurimuppalla]

Hi,

Is there any CLI command in CW9166 AP to enable, disable and read the sensor data such as temperature, humidity,

air-quality from the built-in sensors?

[Leo Laohoo · Accepted solution]

---

@madhurimuppalla wrote:
read the sensor data such as temperature, humidity,air-quality from the built-in sensors?

---

From the WLC: 

test platform software database get ewlc_oper/ap_temp;ap_mac=aaaabbbbcccc

test platform software database get ewlc_oper/ap_air_quality;ap_mac=aaaabbbbcccc

 NOTE: 

1.  The sensors can only work when DNA Spaces have "seen" the APs.  Without DNA Spaces, the sensors will be disabled.
2.  The two commands are present in 17.9.X & 17.12.1 but they are absent in 17.6.4.

From the AP, try:

sh thermal-control-summary

 NOTE:  

1.  This command should be available without DNA Spaces.  

2.  Take note of CSCwh60483 & CSCwk74648.

[madhurimuppalla]

Hi,

Is there any CLI commands in CW9166 AP to check the status of Monitor Radio, BLE, AP power consumption details and also  sensor data like  humidity, air-quality from build-in sensors?

[balaji.bandi]

Most of the information can get from Parent WLC what you looking if the AP register with WLC.

you can refer below thread :

https://community.cisco.com/t5/wireless/cli-command-for-cw9166-access-point/td-p/4951803

[Leo Laohoo]

Has the 9166 been added to DNA Spaces yet?