But that does not answer my questions - refer to my post below. We need to see the full output and running config for the switch and AP ports to have any chance of helping you.
- The access point may be broken , what is the status of theLED indicator, on top of the AP ?
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? ' When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
Provide "show int fast0/0" and "show run int fast0/0" (I presume that is the switch port because the AP does not have a f0/0 interface) And the same for the AP port: "show int fast0" What controller model and software version are you using? Note that that AP model is very old and end of support!
