12-08-2022 01:45 PM
Prime 3.10 report that my 9120AXI units have either 2 radios, a+b (xor) Traditional or 3 radios a+b (Xor)+n the 'n' defined as aux radio main
All my units are configured the same with only one drawing 30w poe and 8 drawing 23.2. Yes that 3 radio ap is reporting 30w but some of the 23.2 units are also reporting 3 radios. One of them has flipped the xor radio to A. thus operating a+a+n
Where is that AUX radio turned on or off?
12-11-2022 06:50 AM
You don't mention what WLC you're using or what version of software?
Is this maybe the Bluetooth Low Energy (BLE) radio?
Check out: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-2/config-guide/b_wl_17_2_cg/ble_beacons_in_ciscowave_2_access_points.html and
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-10/config-guide/b_cg810/location_services.html
Those might help if it is the BLE radio.
12-11-2022 11:02 AM
Hi Rich,
the airos is 8.10.181.3. I just checked and my 9117's are all depicted with the normal 2 'lobe' symbol. however, when the 9117's were on the 9800-40, Prime depicted them with 3 lobes.
I don't have location enabled as the ap's name says it all and everything is working fine
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: