03-27-2019 08:15 AM - edited 07-05-2021 10:08 AM
Hello everyone.
I have been searching for a while but with no findings i will try to ask myself, is it possible to schedule a reboot of a single Access Point that is connected to a WLC?
The only thing that i find is to reset all AP's with the comand reset-aps.
Does anyone knows if it is possible?
Thanks for the help!
03-27-2019 08:58 AM
to immediately reset an AP you can use
config ap reset <ap>
If you want to schedule a reboot at a specific, you could use a scheduled task on PI, write a small script to reset the AP by cron/SNMP or use EEM on the switch to shutdown/no shutdown the port of the AP at a specific time.
03-27-2019 02:53 PM
Can do this 2 ways:
Prime Infrastructure Scheduled task
Script to run the command via the WLC CLI
08-21-2019 01:02 PM
Could you please help us know how we can schedule through prime infrastructure.
and also the script if we have to reboot multiple ap's.
03-05-2020 06:44 AM
03-05-2020 08:34 AM
03-05-2020 08:45 AM
Thank You
03-27-2019 10:59 PM - edited 03-28-2019 11:56 PM
Remote into the AP and issue the command "reload AT <TIME>".
WARNING: WLC firmware 8.8.111.0 has a bug with the "reload at" and/or "reload in". When the command is used, the AP will reboot immediately (refer to CSCvk55805).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide