03-27-2019 08:15 AM - edited 07-05-2021 10:08 AM
Hello everyone.
I have been searching for a while but with no findings i will try to ask myself, is it possible to schedule a reboot of a single Access Point that is connected to a WLC?
The only thing that i find is to reset all AP's with the comand reset-aps.
Does anyone knows if it is possible?
Thanks for the help!
03-27-2019 08:58 AM
to immediately reset an AP you can use
config ap reset <ap>
If you want to schedule a reboot at a specific, you could use a scheduled task on PI, write a small script to reset the AP by cron/SNMP or use EEM on the switch to shutdown/no shutdown the port of the AP at a specific time.
03-27-2019 02:53 PM
Can do this 2 ways:
Prime Infrastructure Scheduled task
Script to run the command via the WLC CLI
08-21-2019 01:02 PM
Could you please help us know how we can schedule through prime infrastructure.
and also the script if we have to reboot multiple ap's.
03-05-2020 06:44 AM
03-05-2020 08:34 AM
03-05-2020 08:45 AM
Thank You
03-27-2019 10:59 PM - edited 03-28-2019 11:56 PM
Remote into the AP and issue the command "reload AT <TIME>".
WARNING: WLC firmware 8.8.111.0 has a bug with the "reload at" and/or "reload in". When the command is used, the AP will reboot immediately (refer to CSCvk55805).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: