09-04-2019 10:50 PM - edited 07-05-2021 10:57 AM
I am new to wireless bridging. We have a requirement of point-to-point bridging with 600 meters distance between teh two APs. As we have 1562D LWAPS, so i'm planning to do it RAP-MAP mesh. However, i am not sure if we can allow multiple vlans across the mesh ? If this is feasible, what will be the configuration on switch, rap & map and what is the design constraint I need to take care of ?
Solved! Go to Solution.
09-12-2019 05:28 AM
start reading at this link
Cisco Wireless Mesh Access Points, Design and Deployment Guide, Release 8.0
09-13-2019 02:00 PM
Here is another good resource to look at:
https://rscciew.wordpress.com/2014/11/15/wlc-mesh-network-configuration/
CJ
09-25-2019 02:10 AM
It worked with "Flex+bridge" mode. I was able to pass on multiple vlans with the bridge blackhaul on native vlan.
09-12-2019 05:28 AM
start reading at this link
Cisco Wireless Mesh Access Points, Design and Deployment Guide, Release 8.0
09-13-2019 02:00 PM
Here is another good resource to look at:
https://rscciew.wordpress.com/2014/11/15/wlc-mesh-network-configuration/
CJ
09-25-2019 02:10 AM
It worked with "Flex+bridge" mode. I was able to pass on multiple vlans with the bridge blackhaul on native vlan.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: