09-04-2019 10:50 PM - edited 07-05-2021 10:57 AM
I am new to wireless bridging. We have a requirement of point-to-point bridging with 600 meters distance between teh two APs. As we have 1562D LWAPS, so i'm planning to do it RAP-MAP mesh. However, i am not sure if we can allow multiple vlans across the mesh ? If this is feasible, what will be the configuration on switch, rap & map and what is the design constraint I need to take care of ?
Solved! Go to Solution.
09-12-2019 05:28 AM
start reading at this link
Cisco Wireless Mesh Access Points, Design and Deployment Guide, Release 8.0
09-13-2019 02:00 PM
Here is another good resource to look at:
https://rscciew.wordpress.com/2014/11/15/wlc-mesh-network-configuration/
CJ
09-25-2019 02:10 AM
It worked with "Flex+bridge" mode. I was able to pass on multiple vlans with the bridge blackhaul on native vlan.
09-12-2019 05:28 AM
start reading at this link
Cisco Wireless Mesh Access Points, Design and Deployment Guide, Release 8.0
09-13-2019 02:00 PM
Here is another good resource to look at:
https://rscciew.wordpress.com/2014/11/15/wlc-mesh-network-configuration/
CJ
09-25-2019 02:10 AM
It worked with "Flex+bridge" mode. I was able to pass on multiple vlans with the bridge blackhaul on native vlan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide