Error: Cannot proceed with the activation as there are no packages to activate

[ปลาวาฬทราย RMUTT CPE IX]

RP/0/RSP0/CPU0:ios#adm sho ins ina sum
Fri Jun  5 11:29:49.914 UTC
Default Profile:
  SDRs:
    Owner
  Inactive Packages:
    disk0:asr9k-px-4.3.2.CSCut30136-1.0.0

RP/0/RSP0/CPU0:ios#adm ins activate disk0:asr9k-px-4.3.2.CSCut30136-1.0.0 sync$
Fri Jun  5 11:20:19.985 UTC
Install operation 143 '(admin) install activate
disk0:asr9k-px-4.3.2.CSCut30136-1.0.0 synchronous' started by user 'cisco' via
CLI at 11:20:20 UTC Fri Jun 05 2015.
Info:     The following SMU is not being activated as it does not apply to any
Info:     packages on the router:
Info:      
Info:         disk0:iosxr-infra-4.3.2.CSCut30136-1.0.0
Info:      
Error:    Cannot proceed with the activation as there are no packages to
Error:    activate
Error:    Suggested steps to resolve this:
RP/0/RSP0/CPU0:Jun  5 11:21:38.762 : instdir[255]: %INSTALL-INSTMGR-3-INSTALL_OPERATION_USER_ERROR : User error occurred during install operation 143. See 'show install log 143 detail' for more iError:     - check the names of the packages being activated.
nformation.
Install operation 143 failed at 11:21:38 UTC Fri Jun 05 2015.

How should I do?

Thank you very much.

[ปลาวาฬทราย RMUTT CPE IX]

Oh! Sorry, I install SMU which is different version with the IOS.

Thank you very much.

[xthuijs]

yup that will throw an error :)

say also, if you do show install log <reqid> [detail] it may give you some more pointers that are helpful.

you could also see this error if you apply a fix for a package that you have not installed. eg you apply a bng smu and the bng pie is not loaded.

also for problems like this, it is always good to see the admin show install active details too to provide some more insight, but that is for next time :)

cheers

xander