The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
On a switch-to-switch interface, can we configure both of these commands at the same time, or can we only configure one of them?switchport mode trunkswitchport trunk allowed vlan allinterface GigabitEthernet1/1/3description ****Uplink-Block-Switchswi...
Recently we renewed Public CA certificate from Entrust to DigiCert for ISE system EAP Authentication, and since then, devices have been failing to authenticate via EAP-TLS. These devices obtain endpoint certificates through the BYOD portal. This is h...
Hello all,When I create a VRF on a router or L3 switch, am I creating just a separate routing table (like just a separate dictionary of routes), or am I creating an actual new routing process on the box ? So often in diagrams I will see VRF's represe...
Hi Wireless Community, I am facing a weird wireless instability issue where endpoints will just random disconnects and I am getting no where to start the troubleshooting process. Current wireless network environment: AP Model: C9120AXEAP Mode: Flexco...
Hi,I'm working on a project to benchmark and score Cisco FTD and FMC based on CIS/DISA standards. Unlike other Cisco IOS and NX-OS devices, the FTD and FMC CLIs are very limited. In Cisco IOS/Firewall or NX-OS, I can use the show running-config comm...
Hello all,I've always heard that EIGRP can't handle a lot of routes (like you don't want to blindly redistribute BGP into EIGRP as it could crash the EIGRP process), but I've never heard specifically why that is the case? Is it maybe because of:How E...
Hi, I have a scenario were i have to implement a solution which allows for dual ISP redundancy on spoke into dual hubs in a dmvpn environment. I have created two tunnel interfaces, both have tunnel source set at each respective physical interface...
in general, why asymmetric routing is not useful ?do it create slowness ?anyhow data is reaching to destination from source .Please share pros and cons of Asymmetric routing
Hello All,I recently acquired a Cisco 2504 wireless controller however the previous owner dose not recall the username or password for this unit. Is there a way to reset it back to the factory default username and password? thank you in advance Dann...
Hello,I am doing a LAB with this topology for my network studies, using hardware CISCO 8200 1N 4T CE1 can communicate with CE2 thanks to basic MPLS configuration on all provider-side interfaces of the routers (AS10000), and vice versa. CE2 and CE3 ca...
hello I goofed and uploaded a new image to my Cisco 3750.I deleted the prior image and set the boot flash statement and then used the command boot system flash: old image/new image This caused me to enter into switch: mode I have tried various recove...
Hi, I configured OSPF on my service side in order to have reachability from the cEdge to my end-host in the LAN. This reachability is working well. However the LAN subnet is not being learned by OMP and thus not being advertised to other sites. So, ...
IntroductionWhat is Microsoft Cloud PKI?Cloud PKI and Cisco ISEHigh Level Flow ExampleSolution Validation SetupEntra ID GroupsLicense AssignmentConfirm Group License Assignment in IntuneCreate the Cloud PKI InstanceDownload the Root and Issuing CA Ce...
hi,just like to ask in the controller GUI ALL ACCESS POINTS section, is it possible to filter out AP base on AP hostname?example -AP hostname - "T5RK2BAPxx-CA" in the AP name column > filter > contains >how to filter out all AP w hostname that contai...