Application Networking

I have an ACE 4710 configuted in one arm mode so I am using SNAT PAT to ensure that server replies go back via the ACE.This PAT pool is running out of TCP ports as I only have 1 address currently in the pool.The load balancing is to 4 CAS servers doi...

Can ACE function as reverse proxy without the ACE Web application Firewall?

Hi,I am a complete newbie on css configuration. I only have configured load balancing on apache with a very simple setup. I have to deploy 2 applications on my clients environment that run inside jboss. One of these applications needs session to be s...

Low DRE comrpession detected for serverI am getting this warning on one of my WAAS appliances.  Has anyone else seen this?  This is on a WAE 502 device running v5.0.1The mispelling of "comrpession" is a copy and paste from the warning message Thanks

Hi,I'm currently seeing the counters for the 'Total Connections Failed' statistic increasing by a large amount. What I can't see is why. The serverfarms we have don't see to show any drops.Using ANM 5.1 we also see this under 'Monitor' 'Load Balancin...

Good morningWe have many instances of configuration across many ace devies where we source nat traffic that is on the server side vlan of the ace module.  All of the vips in these examples are for tcp 80 or tcp 555 or tcp 443 etc etcThey are configur...

HI all,Our WAAS Manager had a HDD failure. The drive was replaced, and is now obviously a blank manager, is there a way I can import the config from the WAVE devices?

Hello, I'm configuring ACE 4710's for the first time and I want to load balance my Nuance speech servers on port 554. Here's my configuration on ACE01:hostname ace471001interface gigabitEthernet 1/1  switchport access vlan 1000  no shutdowninterface ...

Hi,Can anybody help me to know the use of "action rewrite" command:policy-map type loadbalance first-match XXXXXclass class-default    serverfarm YYYYYYYaction REWRITERegards,Thiyagu

I have a GSS 4490 but only want it to be authoratative for certain hosts. Sysadmins don't want to lose control of their DNS records.How do I point active directory to the GSS to look up the host?I need to keep the AD domain as authorative for the DN...

Guys,I would like to know if allowing vlans under portchannel will replicate on standby unit.Somehow I see all configuration is sync except  switchport trunk allowed vlan under Portchannel.              ThanksAjay

Hello All,I am planning to perform a failover drill between active and standy CSS loadbalancers which are configured in a cluster pair.  I am looking for help to know what show commands I can run to validate that the failover occurred successfully fr...

I am trying to configure WCCP on  my Routers in a DMVPN environment, in order to setup WAN Optimization. The issue is as soon as i activate the WCCP service on my ASR or any router at my remote sites with either 'ip wccp 98 group-list ACL' or 'ip wcc...