Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a question about the ACE 4710. I have running two boxes in Active / Hotstandby mode.At the boxes there is running an admin context and addtionally a Loadbalancing context. There are alredy 3 VLAN's where the boxes does...
Hello, I am wondering what HTTP version ACE uses when sending HTTP/HTTPS probes to a web server. I am currently running A2(3.3) if that has any bearing. TIA
This is a fairly basic question but I just can't put my finger on a definitive answer anywhere - if a file in a prepositioned fodler changes after the last sync, will a user accessing the file get the prepositioned version from the last sync or the n...
Hi All,We are currently testing ACE Module feature to do http rewrite on backend server.Users will access http://VIP/test, and ACE should rewrite the request to http://VIP/prodI have checked config-guide and Netpro case-studies but no result. User st...
hi allThe MAPI is common used in many environmentssometime user will encrypt the MAPI traffic with the native encrypt in outlookbut, WAAS SSL acclerate like not support accelerate encrypt MAPI traffic nowI just want to knowdoes WAAS will support this...
Hello, I have one question please....I have 2 servers for loadbalancing, www page is working for everybody, but I still see total conns established=0, do you know why? Or how to check if load balancing is working? thx a lotserver1, serverfarm, state ...
Hi ,My requirement is as followsmy website is http://abc.comanother website is http://xyz.com we are supposed to expose outside world url http://abc.com only. when the client access http://abc.com/myurl1 or http://abc.com/myurl2 then it should be ser...
Hi All,I have a pair of ACE30 in Active/Standby mode. I can ssh to all active contexts. I can also ssh to all standby contexts except one. Could anybody please advise how should I go about troubleshooting this issue?Regards,Nilesh
Hi,do we always have to layer-3 interface of the server vlan on the ACE so as to setup a load balancing?i.e. support i have server 1 (10.10.1.1) and server 10.10.1.2).do I always have to define server vlan for these servers (that's default gateway of...
I have a WAE-7326, which is EOL, but despite being EOL is still a way more powerful than the 674-8gb. The only problem is that I can not get TAC support on it. So, I read on this web page:http://www.cisco.com/en/US/docs/app_ntwk_services/waas/wae/i...
Hi I've got an ACE module in a 6500 that is being used as an SSL Proxy For a web service.So the configuration is fairly basic, matches a VIP which has been Nat'ed from the public IP address port 443 and load balances over a number of reservers with t...
Just migrating our waas farm. Couldnt do a big bang cutover so thought of migrating the core first to 4.4.5c and later edge wae. At the moment both are in 4.2.3b. Did some testing in our lab and found there are no policies in the edge after i migrate...
Hi All,I am getting memory size does not match with model type" alarm in Cisco WAE-674 Appliance. Attached is the required information.Waiting for your kind response.
Hi Does the ACE support the following.We have a home grown application. Client-Server application. Application uses native TCP traffic. Client initiates the TCP connection to a TCP port on the Server. After three way TCP handshake, client writes appl...
