Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a back-end ACE which needs to create a sticky based on a header value. The X-Forwarded-For header is perfect as it indicates the original client ip. There is a front end ACE which is setting the header correctly. My goal is to have ...
I'm currently load balancing a couple FTP servers and the vendor is asking me to make sure to have IP passthrough and no header rewrite. I believe he is looking at a different company LB. What is the Cisco terms for that? Is this something that I nee...
I'm configuring ACE to enable the XML-HTTPS interface so I can import it into ANM, when I try to do a "match protocol xml-https any", I get a invalid command detected. When I tab at the match protocol command, I don't see xml-https listed (http, http...
I am running WAAS Mobile Server 3.5.3 in our test environment and I have clients that are peering with the server but they do not show up in the admin interface on the server. It says that there are no connected clients but the clients clearly show t...
Hi all. I have an ACE context with many bridges configured, for example:Bridge 1 with vlans 10 and 20Bridge 2 with vlans 30 and 40Vlans 10 and 30 connect to clients and vlans 20 and 40 connect to servers.Vlans 10 and 30 are transit vlans betwen a FWS...
Hi all,One of our site have an MPLS as primary line and an 574 toghether with inline card.Now the site needs an backup line, setup with VRRP as shared ip number.The backup device is not an Cisco, and we can’t use WCCP, or HSRP.Should we use the secon...
Is it possible on the CSS11503 to create a layer 5 content rule that matches a url "/*/_edit", so that the following example URLs are matched by the content rule:http://www.example.com/mysite1/subdir1/subdir2/_edithttp://www.example.com/mysite2/subdi...
folksi've inherited a cluster of CSS11501s and i'm never really used them beforecan someone point me in the direction of a good troubleshooting guide please?i'm running CSS11501# sh versVersion: sg0820101 (08.20.1.01)Flash (Locked): ...
Hi,can someone please send me the link which has got capacity data for ACE Module as well as appliance. I need to know how many bindings we can create on these. ThanksAjay
Hi AllI currently have a requirement to run a ACE context in a bridged mode which has groups of servers that need to source NAT'd to single addresses for outbound connections to single internet host. Connections are sourced on the 'server side' ACE i...
Hi,I'm currently working on migration from CSS to ACE. The ACE appliance is running A4(2.0) code. And i couldn't find the CSS to ACE conversion tool in the Web gui. Anybody faced the same issue?merci,arun
We are doing analysis on blocking the source IP's, the actual usage from this source IP's, to what URL's, authenticated / non authenicated etcis there any solution to trace out the User requests & url response from particular farm behind the source...
Dear All,i am having issues deploying Cisco WAE 7341 & WAVE 247 in a datacenter. I need a brief installation steps to install both equipment , and connect both into the network using the right cable and ports , such that the device is visible on the ...
expertsI have installed anm 4.3 and is trying to setup monitoring my css11506. I have added the device and on the monitoring-setting-polling status, said the polling configuration is enabled, but the polling status time out.The css11506 snmp configur...
