Application Networking

Hi AllI am completely new to setup of ACE devices and have inherited a design from a sales specialist that has since left our company. Basically, we have a Production site and a DR site. We have four subnets between the two sites, these subnets will ...

I have 2 servers under a server farm ,the servers are up and operation and  even the probe is successfull.But in the logging I keep getting this error message ,when I did my research ,cisco website states if we continuosuly get this error ,please con...

Hello All,I have a probe config as below:probe http healthcheck  interval 5  faildetect 1  passdetect interval 2  passdetect count 1  request method get url /healthcheck.aspx  expect status 200 200  expect regex "Name = ASR"The ASR health check page ...

Hi All ,We  are facing  the dis connectivity  issue in the the http session ( sticky configuration ) As per the customer requirement we  configured the  http sticky  with the connection time out 60 min ( one hour ) .But  as  per the test with  the to...

Hi GuysI need some advice regarding the Cisco ACE design. I am designing a solution for a pair of Cisco ACE devices which needs to load balance between 2 https website address. The first website is supported by 2 servers and the second by a single se...

Hi,My client has a website and his request is some of the pages need to be redirected to httpsfor example his site is rad1.booking.com and only these pages needed to be using https since it requires confidential entriesrad1.booking.com/ibe/passengerD...

We are facing a challenge with Virtual desktops in our remote sites.Our remote office users use either VDI thin client (like WYSE) or normal computer to connect to their VDI in the data center.The WAN optimizer we use is WAAS between the remote site ...

Hello,I'm don't have many experience with Cisco ACE and I'd like to know if it's possible to have the clients and the servers located at the same VLAN (192.168.0.0/24). The clients will make the http request to a VIP address (10.0.0.10/24) and the AC...

Hi,We have a pair of CSS 11501,Currently it is using source ip for load balancing and 5 servers as backend , however we have users loggin in using http and based on its source IP (ISP PROXY) , it is forwarded to SERVER A.However, we have a SSL page a...

I deployed waas mobile 3.5.1 on windows server 2008 64bit. After created about 100 clients, the system encounter memory corrupt errors:"Data failed to load: Attempted to read or write protected memory. This is often an indication that other memory is...

Hello,i have ACE 4710 appliance that terminate SSL and the connection to the servers is http.The ACE (one Armed) is load balancing between two web servers and i am using stickness in order to take the connection on the same server based on cookie.I c...

HelloDoes anyone know what the error message below means? We just installed a WAAS at this location. 2011 Sep 22 07:05:00 branchwaas1 kernel: %WAAS-SYS-3-900000: x.x.x.x:37679 - x.x.x.x:80 - Packet Flags are incorrect. Dropping the packet(skb=ffff810...

The upgrade process for ANM virtual appliance 4.2 involves doing a backup and restore as root user. I have looked through the documentation and have even reinstalled the virtual appliance to see if the install script gives away the root password for ...