Application Networking

On the ACE in order to get the application to work we are using cookie insert. The rproblem we are having is when the user logs out of the application we would like the cookie to expire, but right now they stay connected to the same server when they ...

Hi,We have an ACE module running on a 6513 chassis and already there are some vlans created in sup module intended for ACE. svclc command is already used in sup module to get these vlans in ace. I am adding one more vlan towards ace. Can i add thi...

HiI'm trying to configure the DNAT for the traffic that is coming from the outside network.I found some examples in the ACE config guide, but none of them shows how to do the following thing (if it is possible at all).I'd like to hide the rserver und...

HelloI am trying to configure the server initiated connection on the CSM-S working in bridge mode.As far as I was able to check, the SYN packets are leaving through the CSM. The SYN-ACK packets are coming to the CSM from the client vlan but, somehow,...

I have a ACE checkpoint question. when u create a checkpoint to save the config on the ACE module where does the file get stored

Hi all,Is there any cli command that gives us an overview of the Total Optimized TCP Connections in the box for that moment ?Best Regards,Bruno Petrónio

Hi Guys, I have problem for Authentication Windows File Sharing.I have environment with WAE 674 (HQ) and 2 WAE 512 (CM,BR) using version 4.1.1d and using WCCP protocol Problem:Slow time (30 s) for open authentication Windows File Sharing. I'm confi...

I have a WAE running 4.1.3 that registered successfully to the CM but is failing to pull the config from the CM (also at 4.1.3). It shows up as activated and online, but nothing shows up under the Services column within CM - where you typically see ...

I have a remote site that is seeing the following errors:(scsi0:A:2:0): Probable outgoing LQ CRC error. Retrying commandSCSI disk error : host 0 channel 0 id 2 lun 0 return code = 10000 SCSI I/O error: POSSIBLE BAD DISK -- device 0x820, sector 10453...

Is it possible to schedule a reload of an ACE appliance? Can yuo advise cmd's if so. Regards William

Users on the edge site are unable to access some websites in DMZ. Some links work and some do not. How to troubleshoot? The page seems to load but never completes. Sent Connection statistics to Cisco and no solution yet.Any inputs are appreciated.Tha...

Trying to get an ACE blade to do L3/L4 load-balancing in one-arm mode, but using PBR rather than source NAT.Got a base config together and load-balancing seems to be working Ok. The problem I am trying to figure out is how to deal with direct flows,...

Hi all,After configuring ntp server, the time is syncronized with no problem at all.The issue occurs when the router reloads/turns off, and when it goes up, the hour in the NM-WAE, will never sync automatically.I always have to delete the ntp configu...