Application Networking

Dear All,I installed the blue coat on one of the vlan with users in diffwrent vlans. The core 4507R is used with L3 vlans as gateway for the respective vlan users. Now i need to configure both core switch and blue coat as proxy server so that all the...

what is the impact to the cpu of the ssl module if we change from 1024 to 2048 bit keys?Actually we have more than 60% of cpu on the ssl modules. So it would be nice to know the impact on the css prior the change.Andre

Good Morning.I've got a question on how to combine subnets. I have 3 small closed networks, all utilzing a ip range of 192.168.1.xxxThese networks have no "outside" connectivity to the world and are located in 3 seperate physical locations. To allow ...

Hello,I am trying to configure a coonection between a CSS 11503 and a 3750 switch via a fiber to RJ45 converter and got problem to get connectivity. By the way i am also having the same issue to set up my ISC link between my two CSSs (both are CSS 11...

I have the following test setup : internet----ASA----ACE(a user context)---client.I have some problems with icmp messages being dropped and some traffic that is not allowed.How can i debug blocked traffic on the ACE ? I can't put a "log" entry on the...

Do I have to do anything on the CSS in order to be able to successfully ping servers hanging off the routed CSS? My network setup is as shown below. I can ping the circuit IP address connected to the server farm but can't ping anything on the server ...

hi, does anybody know if it is possible to stick a user based on their source IP address to a particular service on a CSSthanksNicky

Hi,I have a similar question joerg.micheel already asked about Configuration Synchronization of CSS boxes.My first box CSS-1 is already setup with the config as shown at the bottom (excluding Services, Rules),and i have already reserved IPs for CSS-2...

hi,I have a problem with MTU size (I got ICMP fragmentation needed from router, required MTU size is 1545bytes). ok, I did some packet traces and configuration changes:1.I tried change MTU size on ACE interfaces (routed mode) - without success, MTU s...

HiIs it possible to load balance TLS through a CSS without doing the SSL termination on the CSS? The application is only making 1 connection via TLS on port 4111.Thanks

I have an issue where CSS is still sending requests to a server even though it has detected through the keepalive page that the server should be offline.My setup is that I have front end webservers accessing an XML webservices backend through a CSS. ...