Application Networking

Hi to alli have a question regarding PBR on the CSS. I have a configuration with 4 VLAN (2 vlans are outside, eg vlan 3405 and vlan 3403) and 2 vlans are inside(vlan 3407 and 3410). I implemented PBR on the CSS so that i have 2 default route point to...

Hello,We are using a non-cisco WCCPv2 client with L2, mask assignment with 2 groups to redirect all TCP and UDP pkts.TCP wccp redirect-in on ingress vlan works perfectly (hw switched etc). But when we use redirect in for the udp group, udp pkts are n...

Hopefully I am not repeating a thread but am trying to clarify something.We are trying to come up with a network design template that we can reuse later down the line.Have been looking for best practices on the setting up of a CSS 11500 and have foun...

Topology is as follows: -Cisco 6509 connects to the Bluecoat via VLAN 20 & to Cisco 10 K via VLAN 30. The clients are connected to the internet via 10K. Cisco 6509 connects to the internet via ATM link. We have RPR ring as well, which also connects t...

Hi All,I recently moved the backend of the CSS and associated servers to a new vlan. 2 days prior to that, there was a database upgrade for the same application.Ever since the vlan change, customers are complaining that they are forced out of the app...

Following issue...Two ACE Contexts -> Admin and TestBoth are configured to authenticate via AAA and Radius. Everything works as intended, roles get submitted by Radius etc.If you configure a deadtime >0 and for example you stop the Radius Service the...

Trying to get a gauge on the going rates for building a Load Balanced network using CSS or CSS-type devices for clients.

Hi, As per the Cisco document tried to reset the password for VPN Concentrator. But the boot process was not interrupting while pressing the Ctrl + C. Please advice how to reset the password now.Thanks in advance.

Is it possible to have the servers you are trying to load balance connected directly into the same chasis as the csm-s is in? Or do I have to run policy routing or what is the best design for this? Thanks.

Hi all,Could anyone out there possibly provide an idea/config, of how it is possible to'fail-over' a CSS11503 set-up in Active/Standby mode with "ASR" enabled when:-- ALL your real servers(Services) for a particular VIP 'die'/OR nic is faulty. - So N...