Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

I need setup SSL termination on my CSS11506. I am trying to migration the CA from oracle/apache/solaris9 and find they do not use private/public key, but wallet.How can I do with wallet? is possible to migrate wallet to CSS11506? if so, how to do it ...

julxu by Level 7
  • 785 Views
  • 4 replies
  • 0 Helpful votes

Hello all.The arp cache timeout of the csm is normally 4 hours.Now if we want to replace one of our servers we would need to wait 4 hours before the new servers mac address is learned if we keep the old ip-address.I know we can manually flush one ent...

daniel by Community Member
  • 526 Views
  • 1 replies
  • 0 Helpful votes

Hi,I would like to know what is the main purpose of use the "standby" at the "inservice standby <group>" defined under the virtual server?. It's just a information ("as description") to associate the HSRP standby into this virtual server or it's have...

Hi,I am configuring a Sorry server and have a question about a note I found in a cisco document.Here is the note in question:"Note: After the CSS 11xxx directs requests to a primary sorry server, the switch continues to use the primary sorry server, ...

jaredmiller by Community Member
  • 878 Views
  • 1 replies
  • 0 Helpful votes

Following problem is occuring to a couple of our css running version 07.40.1.04.The system is running in redundant configuration active - standby isc interconnected.The css are configured to handle mutiple url to be loadbalanced to a farm of 8 server...

hvd by Community Member
  • 908 Views
  • 3 replies
  • 0 Helpful votes

Giles,I just want to configure a simple redirect where all initial requests for content on port 80 of a given vip is redirected to port 433 on that same vip, regardless of the url. Suppose I have the following:----------------------------------------...

laschb by Community Member
  • 612 Views
  • 1 replies
  • 0 Helpful votes

Hello all.The arp cache timeout of the csm is normally 4 hours.Now if we want to replace one of our servers we would need to wait 4 hours before the new servers mac address is learned if we keep the old ip-address.I know we can manually flush one ent...

daniel by Community Member
  • 760 Views
  • 1 replies
  • 0 Helpful votes

Hi, There: I have two URLs on the same server same port,/test1//test2/I want to give all users access /test2, but I only want to give user at network range 10.0.0.0 255.0.0.0 to access /test1, how should I do that?Thx

mike by Level 1
  • 843 Views
  • 5 replies
  • 0 Helpful votes

Is there anything available from cisco or a third party that our noc could use to perform the following commands for our csm and css11506 units? Something that is graphical and easy to hand off?real (ip addresss)no inservice or inserviceservice (nam...

sandersona by Community Member
  • 632 Views
  • 2 replies
  • 0 Helpful votes

Does anyone know how long is the wait time for the built in http get keepalive before it determines there's no answer and marks the service as dying? And is this configurable somewhere? I have an App owner who thinks the load balancer may not be wai...