Application Networking

Hello,Suppose I have a pair of PIX, a pair of CSS and a server farm. What should be the placement from the outside to inside? PIX-CSS-servers or CSS-PIX-servers? What are the considerations?Of course, by using a pair of PIX and a pair of CSS I want t...

Hello!I would like to send syslog messages via the Ethernet management port on the css. I set up a management route, and tried to set the logging host command, and I get the following:%% SYSLOGD cannot go to local I/F, VIP, or APPCould anyone help me...

Hi all, If a second SCM is installed in a CSS11506 Chassis, what is the amount of memory on board. I know the primary SCM has 288MB on Board. But some information say that only 144MB are on the redundant SCM Module. Help needed urgent. Regards Richar...

Hi, i'm using CSS 11501 to load balance some web servers with advance-balance methods cookies.which is best the method of loadbalancing with it sticky method ??balance leastconn or balance roundrobin Thank you in advance!

Dear All,If I buy a content engine, do I receive a CD media?I am thinking of system recovery by this CD if the system is crashed!Thanksmak

Hi,Can the CSM be used in both the bridge and router mode for different VLANS ? Or does it need to use all router mode and all bridged mode ?

Out server sends responses in this format (XML)<RETURN> <INFO COUNT="number"></RETURN>number is 0 for error, or something greater than zero if it works OK.I would like to make a kal script for it.So i tried (only socket commands)! 1 - started it with...

I'm migrating from an SCA to a CSM/SSL Proxy module.I've run into an issue with the SSL Module and URL rewrites. It seems that it does not rewrite urls in the webpage itself.The SCA has this functionality, and rewrites all https url's in a page to ht...

I have an 11501 that is balancing connections between my 10 terminal servers. We are using roundrobin because we were told by TAC that leastconn and ACA do not work well with terminal server environment. The problem is that whenever a server goes dow...

hiI tried check vserver in csm with ping.the result is ping response time flapping that from pc to Vservers in CSM.flapping is serveral time in 1 minute.it's like following this 64 bytes from 169.140.127.242: icmp_seq=33 ttl=125 time=0.429 ms64 bytes...

Hi,Is it possible to configure a backup serverfarm so that when the primary serverfarm receives a certain number of connections (based on L3, L3+L4, or info within L7) all new connections are redirected to the backup serverfarm?Thanks.

Hello,Is it possible to configure the following redirectconnections to www.mydomain.com/news/home.htmlredirected towww.anotherdomain.com/sorryserver/sorry.htmlI have read the doco on this but at the following urlhttp://www.cisco.com/en/US/customer/pr...

Is there a document somewhere which details what service ports are used by Cisco's Content Delivery Network for its internal communications (i.e. keepalives of CEs and CRs to the CDM for status). The CDN I'm setting up will have some CEs on the other...

Is it possible to specify the port that the "snmp trap-host" command will use when sending a trap from the CSS?

I have a customer who wants to maintain sticky between TCP80 and TCP443, so we selected a L3 content rule. content L3_www.ourcustomer.com vip address 1.2.3.4 sticky-mask 255.255.128.0 add service web004 add service web005 add service web006 sticky-in...